Call 01493 277103

Skylights & roof windows

Why Is My Roof Lantern Leaking?

A lantern is a glass crown on a flat roof, and every joint on it can let water in. Read on for how to separate a leak from condensation, where the water enters and what to do before repair.

Get a written quote

Call 01493 277103WhatsApp us

An old brick workshop with a corrugated cement sheet roof and two rooflights

The short answer

A leaking roof lantern lets water in at the joint between the roof covering and the upstand it stands on, at the glazing bars and their cappings, at worn seals or around the corners. Damp that appears on cold, dry mornings is condensation instead. Photograph the damage, then have the roof looked at.

Telling a drip from damp air

Before looking for a gap, check what kind of wet this is. Water that runs down the glass on a cold, dry morning, and clears as the room warms, is room air condensing on a cold surface. Water that arrives during or just after rain, and stains the ceiling edge or the plasterboard beside the lantern, has come in from outside.

Wet signs on a roof lantern
What you seeWhen it appearsPoints to
Beads on the inner glassCold dry morningsCondensation
Mist between two panesAny weatherA failed glazing seal
Drips from a bar or cornerDuring or after rainA joint letting water in
Stain or soft board around the baseAfter rain, spreadingWater entering at the upstand

Our page on condensation on a roof window goes through the damp-air case in full. A leak and condensation can coexist: a lantern that sheds water from a joint may also be misting on the inside, which is why the timing of each drip is worth noting.

Where a lantern lets water in

A lantern stands on an upstand, a raised kerb round the opening, with the roof covering turned up its side. The first place to suspect is the line where covering and upstand meet. If the covering has lifted or split there, or the dressing finishes too low, rain runs behind it into the structure below, and the stain shows on the ceiling around the opening.

The second is the glazing. A lantern is built of glass panes carried on bars, and a capping covers each bar's joint with the glass. Where a capping has lifted, a screw has been left unsealed or a gasket has shrunk, rain works in along the bar and drips from the underside at its lower end. Corners and the ridge are where several bars and panes meet in one spot, so a gap there has several paths in.

The third is the roof around the lantern. A flat roof that holds standing water at the foot of the upstand puts that water under steady pressure on the joint every time it rains. BS 6229:2025 sets "a minimum 1:80 finished fall" for general roof areas, and IKO reports that "To achieve a 1:80 fall, the code of practice says that the roof should be designed for a fall of 1:40". A roof that has settled below that fall makes every joint work harder.

Joints to check on a lantern

  • Covering where it meets the upstand
  • Cappings and screw heads on each bar
  • Gaskets between glass and frame
  • Corners and the ridge
  • Standing water at the base

What to do while the water is coming in

Catch the water and protect what sits below it. Move furniture away from the drip, put a bowl or bucket under it, and lift the edge of a rug. Photograph the stain, the wet board and the lantern from inside, with the date, because a clear record helps whoever looks at the roof and, if you claim on insurance, the insurer. The Financial Ombudsman Service advises photographing damage before anything is moved.

Do not climb onto the lantern. Glass bears little weight, and a lantern on a flat roof is reached safely only with the right access equipment. If the water is heavy, a call-out is the way to stop it; MyJobQuote lists typical call-out costs of £150 to £300 for an emergency roofer, while extensive storm damage repairs can cost £1,200 or more (22 October 2026).

You can also send a picture of the lantern glass and the stained ceiling to our WhatsApp, 07880 284133, so that we see the fault before anyone is on the roof.

Repair, re-seal or rebuild

The fix follows the cause. A lifted capping or a dried gasket is a small repair at the bar. A split or lifted covering at the upstand is re-dressed up the kerb. A kerb that has absorbed water and gone soft is replaced, and then the lantern has to come off and go back. A lantern whose glass has failed in several places may be better replaced than re-sealed, as the guide to roof lanterns explains.

Where the flat roof has little life left, the lantern is lifted when the roof gets a new covering, and that is the moment to rebuild the kerb. The page on flat roof skylights covers the flat glass alternative.

At Total Roofing Great Yarmouth the survey looks over the entire roof, lantern included, and what else we saw is reported in plain words before a single written price is set. A lantern repair is judged against the state of the covering it stands in, since a joint repaired on a failing covering can open again.

Questions and answers

Can silicone seal a leaking lantern?

A bead of sealant can slow a drip at a capping for a time, but it hides the cause and does not deal with a split covering or a soft kerb. Water trapped behind a sealed joint can spread. The joint is better opened, dried and put right, so ask for a survey before sealant is applied to glass.

How do I know the leak is the lantern and not the roof?

Look at where the stain sits. Damp that follows the outline of the lantern, and starts at the base or a bar, points to the lantern. Damp further out on the ceiling points to the flat roof covering, a gutter or an upstand elsewhere. A survey traces the route the water took.

Will insurance cover a leaking roof lantern?

The Financial Ombudsman Service says "Rain, hail or snowfall by itself can constitute a storm", and "we'll usually look at expert reports and photos". Cover turns on the terms of the policy and the cause of the leak, so photograph the damage before anything is moved, then tell the insurer and keep the photos with the policy documents.

Get a written quote

Tell us about your roof

Hand dressing a lead ridge roll with a wooden bossing stick

10-year workmanship guarantee, in writing

Call WhatsApp Written quote