Call 01493 277103

Skylights & roof windows

Condensation on a Roof Window

Water on the inside of a roof window is room moisture settling on cold glass. Here is how to tell it from a leak, what ventilation does, and when the glazing is the cause.

Get a written quote

Call 01493 277103WhatsApp us

An old brick workshop with a corrugated cement sheet roof and two rooflights

The short answer

Condensation on the room side of a roof window is damp indoor air meeting glass colder than the air around it. Better ventilation cuts it, and a better-glazed window reduces it. Mist trapped between the panes is a different fault: the sealed unit has failed and needs replacing.

Why the glass runs wet and the wall does not

Air in a house carries water vapour from breathing, cooking, showers, kettles and wet washing. Warm air holds more vapour than cold air, so when that air meets a surface that is cold enough, some of the vapour turns back into liquid. In a bedroom or bathroom the coldest surface within reach can well be the roof window, because glass lets heat through far faster than a plastered ceiling with insulation behind it.

That is why the pane can be streaming while the ceiling beside it is dry. It is also why the water gathers at the bottom edge of the glass and along the lowest part of the frame: the cold runs down the slope and the droplets run with it. A roof window sits at an angle, so drops that form on the underside can fall into the room instead of trickling down a vertical pane, which makes a minor misting look like a drip.

None of this means the window is faulty. A window that clears by mid-morning is doing what any cold surface does in a room with damp air in it. The question worth asking is whether the damp is a short daily event or a lasting one, because lasting damp reaches the lining, the paint and the timber reveal around the opening.

Condensation, a leak or a failed seal

Three faults look alike from a bed or a landing, and each one points to a different repair. The table of signs below separates them using what you can see from inside the room.

Signs that separate three window faults
What you seeLikely causeWhat it means
Beads or film on the room side, worse on cold mornings, gone laterRoom air condensingA moisture and ventilation question
Mist or droplets between the two panes that no cloth reachesFailed edge sealThe sealed unit needs replacing
Drips or a stain that start in or after rainA leak at the flashing or frameThe roof needs looking at

A single window can show more than one of these. A stain on the lining under a window that also steams up is a fair reason to have the flashing checked as well as the ventilation, and a photo sent on WhatsApp to 07880 284133 lets us see which of the three the picture most resembles before anyone goes up.

Ventilation and how the room is used

Because the water comes from inside, the cure sits inside too. A bathroom or kitchen with a working extractor fan, run while the room is in use and for a while after, removes vapour before it travels to the loft room. A closed door between a steamy bathroom and a landing keeps that vapour from spreading up the stairs towards the roof windows.

Trickle vents are small slots in the frame that let a measured amount of air through while the window stays shut. Roof windows can be made with a vent along the top of the sash, and opening it, or opening the window itself for a few minutes, swaps damp air for drier air. Drying washing on a rack in a bedroom with a roof window puts a lot of moisture into a small volume of air, so a room used that way will keep fogging that glass until the washing is somewhere else.

Blinds and curtains matter more than they look. A blind pulled down tight over the glass traps a pocket of warm, damp air against the cold pane, and that pocket is exactly where droplets form. Lifting the blind in the morning, or leaving a gap at the top, lets the room air circulate and the glass clear sooner.

Cutting condensation at the window

  • Run the bathroom and kitchen extractors during use and after
  • Keep the bathroom door shut while showering
  • Open the trickle vent or the window briefly each morning
  • Dry washing in a different room
  • Raise blinds so room air can reach the glass

When the glazing is the problem

Ventilation will not fix a window that is simply cold. A pane with a poor heat-loss figure stays chilly in winter, so it collects moisture even in a house that is well aired. Approved Document L 2021 gives a replacement roof window in England a heat-loss figure of 1.4 W/m²K, or an energy rating of Band B as a minimum, and that sets the yardstick for a new window. A better-glazed window runs warmer on its inner face, so less vapour condenses on it.

A failed seal is a separate matter. Once the edge seal of a sealed unit lets in damp air, mist forms between the panes and cannot be wiped off, and the unit is replaced rather than cleaned. Our page on replacing the glass in a skylight explains when that is possible and when the whole window is swapped.

If a window is old, the first question is the condition of everything around it, not only the glass. For the wider picture see the guide to replacing a roof window, where MyJobQuote gives an average of £1,100 for a standard mid-range Velux window (22 September 2026). At Total Roofing Great Yarmouth we survey the roof around a window as well as the window itself, and what the survey turns up is explained before a single total price is written down.

Questions and answers

Is condensation on a roof window harmful?

Occasional beads that clear within hours are not a roofing fault. Water that sits for days can mark the lining, lift paint and darken the timber reveal around the opening, so a window that runs wet through the winter is worth dealing with at the source, which is the damp air in the room and sometimes the cold glass.

Can I stop condensation by opening the window a little?

Opening the window, or its trickle vent, swaps damp room air for outside air and gives the glass a chance to clear. It helps most when done after a shower or cooking. It is a ventilation measure, so it does not make a poorly insulated window warmer, and a pane with a poor heat-loss figure will still mist.

Does mist between the panes mean the whole window is replaced?

Not always. Mist between the panes means the sealed glazing unit has failed. Where the frame, flashing and lining are sound, the unit can sometimes be swapped on its own; where they are not, the whole window is replaced. The survey settles which, and then one written sum is given.

Get a written quote

Tell us about your roof

Hand dressing a lead ridge roll with a wooden bossing stick

10-year workmanship guarantee, in writing

Call WhatsApp Written quote