Call 01493 277103

Skylights & roof windows

Can You Replace Just the Glass in a Skylight?

Mist between the panes or a cracked pane does not always mean a new window. This page explains what the glass unit is, when swapping it alone makes sense and when the frame and flashing decide otherwise.

Get a written quote

Call 01493 277103WhatsApp us

Conservatory with a solid ceiling and rooflights opening onto the garden

The short answer

Sometimes. Where only the sealed glazing unit has failed, with mist between the panes or a cracked pane, and the frame, the flashing and the lining all check out, the unit can be swapped on its own. Where the frame is tired, the window is discontinued or the flashing leaks, replacing the whole window is the better route.

What the glass in a skylight actually is

The glass in a roof window is not a loose sheet set in a rebate. It is a sealed unit: two or three panes held apart by a spacer around the edge, with air or gas in the gap and an edge seal that keeps that gap closed. The sealed unit is then fitted into the sash, the moving part of the window. The outer pane of a unit is toughened or laminated so a break does not send sharp pieces into the room, and the supplier states what a unit is built from.

That construction explains the two faults. When the edge seal fails, damp air enters the gap and mist forms between the panes. No cloth reaches it, because the surface that is clouded is inside the unit. When a pane cracks, from a knock or a thermal stress, the unit as a whole is compromised and is replaced as a whole.

Both faults are faults of the unit, not of the window as such, which raises the question of whether the unit can be changed on its own. The answer turns on what else is wrong, and on whether a unit of the right size and specification can be obtained for that particular window.

When a unit swap on its own makes sense

A swap of the glazing unit alone suits a window that is otherwise in good order. The frame is sound with no soft timber, the sash opens and shuts, the seals are intact, the lining shows no stains and the flashing has never let water in. In that condition the fault is limited to the unit, and a new one in the same sash restores the window without disturbing the roof covering.

The unit has to match. Its overall size, thickness, glazing makeup and the way it is held in the sash all have to suit the window it goes into, and the maker's data for the window gives the details. A roof window that has been discontinued, or an older model whose parts are no longer made, may not have a matching unit available, and a made-to-measure unit in a sash that was designed for something different is a compromise.

A sealed unit swap also raises an energy question. For a replacement roof window, Approved Document L 2021 names 1.4 W/m²K, with Band B on the energy rating scale as the alternative minimum. Whether a swap of the unit alone is treated as replacing the window for that purpose is a point for building control, so ask which route the address takes before ordering.

Swap the unit or the window

Unit only

  • Frame and lining sound
  • No leaks at the flashing
  • A matching unit exists

Whole window

  • Soft or marked timber
  • Leaks round the frame
  • Model discontinued

When the whole window is the better answer

Several things push the answer towards a full replacement. Timber that is soft or dark where it meets the glass has taken in moisture. A flashing that has leaked leaves the lining and the frame damaged, so a new unit in a wet frame treats the symptom and leaves the cause. A window with worn seals and a hinge that sags has more than one part at the end of its working life.

Price is worth comparing. MyJobQuote gives an average of £1,100 for a mid-range standard Velux, and puts a straightforward swap, where the opening already exists, around £100 lower (22 September 2026). Published averages are no guide to a particular job, so the quote for a unit and the quote for a window are put side by side before a choice is made.

Replacing a window like for like uses the existing opening. Our guide to replacing a Velux-type roof window goes through that swap, and the page on how a roof window is installed sets out the sequence of the work.

Getting a unit swap looked at

A photograph helps. Send a picture of the mist or the crack, the frame and the lining to WhatsApp on 07880 284133 and we look at it. A photo shows the type of fault, but not the size of the unit or the state of the timber behind the lining, so a survey, from outside and from within, settles the choice between a unit and a window.

Because the work is done from the outside of a sloping roof, access has to be planned. Scaffolding that obstructs the pavement or road is a matter for the county council's licence, and we arrange the licence with our scaffolder. Access of that kind is worked out before the date is set, since a window high on a slope cannot be reached safely from the ground. Total Roofing Great Yarmouth surveys the roof near the window and the window together, and the quote is a single written sum for the whole job.

Questions and answers

Can I replace a cracked pane myself?

A roof window unit is heavy, sits on a slope and is fitted from outside, so it is not a job to try from a ladder. The pane is also part of a sealed unit, which has to be matched to the window. A survey shows what is needed and whether a safe way to reach the window exists, and the work goes to someone equipped for it.

Will a new unit stop condensation?

It stops mist between the panes, because a new sealed unit has a sound edge seal. It does not stop condensation on the room side of the glass, which comes from damp air meeting a cold surface, and that is dealt with through ventilation and through the glazing's heat-loss figure, which a better unit may also improve.

Does the roof need to be opened up for a glass swap?

Not when only the unit is changed and the flashing stays in place, because the unit comes out of the sash. If the flashing has to be renewed, or the whole window is replaced, the covering around the opening is lifted and the flashing is refitted with it, which is part of the written job.

Get a written quote

Tell us about your roof

Hand dressing a lead ridge roll with a wooden bossing stick

10-year workmanship guarantee, in writing

Call WhatsApp Written quote