The short answer
A hip roof has slopes on all sides, so there is no vertical gable wall at the ends. The sloping line where two planes meet at an outward corner is the hip, and it is covered with hip tiles. Marley wants hip tiles fixed mechanically, and BS 8612:2018 covers dry-fixed hip systems.
The shape of a hip roof
Picture a simple pitched roof with a gable at each end: two long slopes, a ridge along the top, and a triangle of wall at either end. A hip roof replaces those triangles with slopes. Each end of the building gets its own plane of tiles, leaning inwards, so the roof slopes down to the eaves on all four sides.
Where an end slope meets a long slope, the two planes make an outward corner that runs diagonally from the ridge down to the corner of the eaves. That diagonal is the hip. A house with two end slopes has four hips, and a square plan with all slopes meeting at a point has four hips and no ridge at all.
Variants are described by how far they go. A half-hip, sometimes called a jerkinhead, slopes only the top part of the end and leaves a small gable below it. A hipped-and-valleyed roof is a hipped roof on an L-shaped plan, so it has both the outward corners and the inward ones. The page on gable and hip roofs compares the two basic shapes.
The parts along a hip
A hip is built from a short list of parts, which a survey looks at in turn:
- Hip tiles, laid along the line over the meeting edges of the two slopes. They may be half-round, angled or the shaped kind called bonnet hips.
- The cut tiles on each slope, which are trimmed to follow the diagonal and sit tight against the hip tiles.
- The hip rafter below, which carries the load along the diagonal.
- A hip iron, a metal bracket screwed to the rafter at the lower end of the diagonal, which stops the bottom tile sliding.
- The cap at the top where the hips meet the ridge, which may be a ridge end tile or a block of mortar.
Every one of these can let a hip down. Cut tiles crack, bedding loosens and a hip iron can rust or work loose. Our page on bonnet hip tiles looks at the shaped tiles that sit on the line.
How a hip is fixed
Hip tiles sit along a diagonal with open air around it, and the fixing has to keep them there. Marley's advice treats ridge and hip tiles alike: each gets a mechanical fixing sized to the uplift worked out for that roof. It adds that the 2015 amendments mean mortar was no longer to be the sole fixing for a covering.
BS 8612:2018 is listed as current and is the specification behind dry-fixed ridge, hip and verge units. A dry hip system uses clips, brackets and screws fixed to a batten or the rafter, so each tile is held without a bed of mortar. A hip finished in mortar still needs a mechanical fixing under the guidance above.
Installing to BS 5534 is not required by law, Marley notes, but each roof gets its own fixing specification, which looks at how exposed the site is. The hip is part of that specification, along with the ridge and verge.
What a survey looks for and what hip work costs
From the pavement a hip is seen edge-on, which hides a good deal. Signs that call for a closer look include a line of mortar that has opened, a hip tile out of line with its neighbours, a gap at the foot where a hip iron should be, and a sag along the diagonal. A hip tile that has slid or dropped leaves the course beside it unprotected, so rain can reach the battens and underlay.
At Total Roofing Great Yarmouth the hips are surveyed along with the ridge, the verges and the rest of the covering, so one finding does not hide another. Hip work is priced after a survey, because a ridge figure cannot stand in for a hip, and hip length, access and bedding condition all change the job. The price is delivered as one written total.
For the roof as a whole, see the pitched roofing service. A tile that has slipped on the line can also be swapped on its own, as the page on replacing one ridge tile explains for the ridge, and the principle is the same.


