Call 01493 277103

Skylights & roof windows

Roof Windows on a Side Slope

A roof window on a side slope of a house comes with a planning condition about glazing and opening. This page sets out what the condition says, what it leaves alone, and where to check first.

Get a written quote

Call 01493 277103WhatsApp us

Glazed roof lantern panes from below, blue sky

The short answer

A roof window on a side slope can be permitted development if it is obscure-glazed. It must also be fixed shut, unless the opening part sits more than 1.7 metres above the floor of the room. Listed homes, flats and Article 4 areas follow other routes, so check with the council.

What counts as a side slope

A house roof is made of slopes, and each one faces a direction. The slope that faces the street, and the one that faces the back garden, are the main elevations. A slope that faces the neighbouring house, or the gap beside the house, forms a side elevation. On a hipped roof the two small end slopes are side slopes, and on a gabled house the gable end is a wall, so the roof slopes themselves face front and back.

The distinction matters because the General Permitted Development Order treats a roof window on a side slope differently from one at the front or the back. A window put in a rear slope is dealt with under the ordinary Class C test for alterations to a roof. A window on a side elevation slope carries an extra condition on top of that test, and the reason is the neighbour: an opening window high in a side roof looks into the next garden or the next bedroom.

If you are not sure which slope is the side, stand where the front door is and look at the house as the road sees it. The side slope is the one running along the edge of the plot. Where a house stands at an angle, or has an extension with its own roof, the survey can sort out which slopes the condition covers.

The condition on glazing and opening

Class C of the order covers "any other alteration to the roof of a dwellinghouse". The householder technical guidance on GOV.UK reads it as taking in work such as re-roofing or roof lights and windows. Re-roofing a house is normally permitted development under Class C, and a roof window is one of the alterations the class covers.

Condition C.2 then deals with the side slope. A window on a slope forming a side elevation has to meet two tests. The first is obscure glazing, with no exceptions. The second is that it must be non-opening unless the parts of the window which can be opened are more than 1.7 metres above the floor of the room in which the window is installed. Only the second test is relaxed by height.

The same guidance says side windows should be obscure glazed to a minimum of level 3, a grading of how much the glass blurs the view, which the supplier states for each pane.

The height is taken inside the room, from the finished floor. A tall sash high in a steep slope can reach past 1.7 metres at its top edge while its lower edge falls short, so the check uses the real sash and the real floor level.

Side slope or rear slope

Side slope

  • Obscure glazing always.
  • Fixed shut below 1.7 m
  • Houses only, not flats

Front or rear

  • No side-slope condition
  • Other Class C limits apply
  • Ask about Article 4

The other limits that apply to any roof window

Passing the side-slope condition does not settle everything. Class C is also limited by what the alteration does to the roof. Under C.1(b) it must not protrude more than 0.15 metres beyond the plane of the slope of the original roof. Under C.1(c) it must not make the highest part of the alteration higher than the highest part of the original roof. Both limits are tested against the finished window, so the product's own height above the covering counts.

Chimneys, flues and soil and vent pipes sit outside Class C under C.1(d), as do solar photovoltaic and solar thermal panels, so a roof window job that moves one of those has a separate planning question.

Not every home has these rights. A flat, or a house converted into flats, has no householder permitted development rights at all, so the roof window question there goes to the council. A guide to the planning side of roof work as a whole is in our planning permission guide.

Listed homes, conservation areas and the Broads

Class C has no exclusion for article 2(3) land, the term for the Broads, conservation areas and National Landscapes. Dormers and other roof enlargements under Class B lose their permitted development rights on that land, but a roof window is a Class C alteration, so that loss does not by itself stop one. An Article 4 direction can remove further rights, so the council is asked whether one applies to the street.

A listed home keeps its Class B and Class C rights, but anything done "in any manner which would affect its character as a building of special architectural or historic interest" needs listed building consent. A side-slope window on a listed house is therefore a listed building question first. Inside the Broads executive area, planning goes to the Broads Authority, which is the local planning authority there.

For the planning side in conservation areas and on Broads land, see our post on roof windows in a conservation area or the Broads. For the energy and structure rules that apply whatever the planning answer, read the guide to Building Regulations for roof windows. Total Roofing Great Yarmouth checks the route with the council, or the Broads Authority where it applies, before work begins.

Questions and answers

Can I have an opening roof window on a side slope?

Only where the opening part is more than 1.7 metres above the floor of the room, and even then the glass has to be obscure-glazed. Lower than that, the window must be fixed shut as well as obscure-glazed. The height is taken inside the room, with the floor as the starting level.

Does obscure glazing apply to a window at the back of the house?

No. The glazing and opening condition is aimed at a roof slope forming a side elevation. A window in a rear slope is judged instead under the other Class C limits, which cover how far it stands proud of the roof and how its height compares with the original roof, and a flat has no such rights at all.

Do I need building regulations approval as well as planning?

They are separate systems. Planning looks at the appearance and the neighbour, and Building Regulations look at energy, structure and escape. A new opening that cuts a rafter has structural consequences, so ask building control which route applies, as our types of roof window page shows for the fittings themselves.

Get a written quote

Tell us about your roof

Hand dressing a lead ridge roll with a wooden bossing stick

10-year workmanship guarantee, in writing

Call WhatsApp Written quote