The short answer
A lead hip roll is a strip of lead dressed over a rounded timber core along a hip, the sloping outward edge where two slopes meet. On a slate roof it takes the place of hip tiles, and it is held at its head and along its sides so wind cannot lift it.
What a hip is and why it needs covering
A hip runs from the ridge to the eaves along the outside corner of a roof that slopes at its end, as on a hipped roof or over the corner of a bay. Rain runs down both slopes and meets at the hip, where the slates on each side are cut to a line and leave a joint between them. Unless something covers that joint, water runs into the roof.
On a tiled roof the cover can be a set of special hip tiles, bedded in mortar or fixed dry. The current British Standard for dry-fixed hip, ridge and verge systems is BS 8612:2018, and Marley holds that each hip tile should be fixed mechanically against the uplift calculated for the roof. On a slate roof another choice exists: a roll of lead, shaped over the joint and left to weather to a dull grey.
Our guide to types of lead flashing sets the hip roll beside the other lead details that a house can carry.
How a hip roll is built
Beneath the lead sits a core, a length of timber with its top edge rounded, laid along the hip. The slates are cut to meet the core on each side, and the lead is dressed over it and down onto the slates. The lead is fixed at its head, near the ridge, and clipped along its sides so a gust cannot get under an edge.
- The timber core is fixed along the hip line and its angle checked against both slopes.
- The slates on each side are cut to the line of the core.
- The lead is cut into lengths, dressed over the core and down onto the slates.
- Each length laps the one below it, and the head of the run is fixed at the ridge.
- The sides are clipped, and the lower end is shaped to shed water at the eaves.
Leadworx, a flashing maker, lists codes 3 to 8 under BS EN 12588, and the specification decides which one goes into each detail. The lap of each length and the gap between clips are specification matters as well, and no figure is made up here to fill the space.
Where hip rolls are used
A hip roll belongs on slate roofs, because lead lies close to a slate edge and weathers to a similar grey. It can also cover the corner of a hip on a bay window roof, where the covering is slate or tile and the joint is short. Our page on lead bay window roofs covers that case.
Cupa, a slate maker, reports a minimum of 20 degrees under BS 5534 for natural slate at moderate exposure, while hook fixings are ruled out below 25 degrees. Those are figures for slate and not for lead, but they show why the pitch and the exposure shape each choice on a slate roof, and a hip is part of the same system.
A listed building's roof is part of its character, so a switch from one hip covering to another can need listed building consent. Check with the council before anything is ordered, and keep the existing detail until the answer comes back.
Faults, repairs and the price
A hip roll can fail where the lead has split along the crown of the roll, where the head fixing has pulled out so the lengths slide, or where a side clip has gone and wind lifts an edge. The core can rot if water has been passing a split, and a soft core shows from the ground as a dip in the line of the hip.
A split in one length can be cut out and replaced, and a loose length can be dressed back and fixed again, but a sagging core means the lead has to come off so the timber beneath can be renewed. The survey says which applies, and it looks at the slates beside the roll for slip as well, because a loose slate at the hip lets water behind the lead.
The ridge tile figures in the cost guides belong to ridges and do not carry over to hips, so what a hip costs is settled after the survey, and you then receive one written total. For the wider picture, begin at the lead roofing and leadwork hub.


