When a pot comes down: stay out of the drop zone
A pot that has fallen has landed somewhere, and the same fall can happen again from whatever is still up there. Keep people, children and pets away from the ground below the stack and from the slope it sits on. Pieces of brick, mortar and pot can slide off the roof long after the first one drops, so the danger area is wider than the spot where the pot came to rest.
Keep off ladders here, and never lean one against the stack. A chimney that has shed a pot may have loose brickwork under the part that fell, and a ladder resting on it can bring the rest down with you. Study it from a safe spot on the ground, using binoculars or a phone's zoom, and let a roofer go up with the right equipment.
Photograph everything before you touch anything, and take more pictures than seem necessary. Take the pot and the debris where they landed, any damage they did to a conservatory roof, car, fence or garden, and the stack itself from several angles. In a storm dispute the Ombudsman says "we'll usually look at expert reports and photos", so pictures taken in the first few minutes are worth having. Tell your insurer before you book repairs; our guide to storm damage and home insurance covers the steps.
If rubble has landed on a neighbour's property, tell them what has happened and show them the photographs. Our emergency roof repairs pages cover the wider picture of what counts as urgent and who to call.
The first hour on the ground
- Keep everyone away from the area below the stack.
- Do not use a ladder against the chimney.
- Photograph the pot, debris and any damage as it lies.
- Ring your insurer and a roofer you chose yourself.
- Leave the fireplace and flue unused until checked.
The parts of a stack and which one let go
Chimney talk is easier once you know the names. The stack is the brick or stone column that rises through the roof. At its top sits a bed of mortar, sloped to shed rain, and into that mortar the pots are set. The pots are the clay or concrete tubes that carry the smoke past the top of the brickwork. Where the stack leaves the roof, strips of lead or other flashing seal the joint between brick and roof covering.
Each part can fail by itself, and the survey has to work out which one it was. The answer decides whether the repair is a small one at the top or a larger one lower down. A pot that has simply lifted out of its mortar bed leaves a sound stack and a bare hole. A pot that took the top courses of brick with it points to a stack with a problem further down. A loose or leaning stack, with no pot yet lost, is the more serious find, because the whole column is moving.
When one piece fails, the neighbouring pieces are worth checking too, because the same weather and the same age have acted on all of them. That is why a roofer surveying a fallen pot looks at the other pots, the flaunching on every one, the brickwork below, the flashing and the condition of the mortar joints all the way down the stack.
Chimney terms
- StackThe brick column above the roof
- FlaunchingSloped mortar holding the pots in place
- PotThe clay tube at the top of a flue
- FlashingLead sealing stack to roof
- CowlA cap that sits over the pot
Why a pot or stack top lets go
Mortar is not permanent. Once flaunching cracks, rain gets into the gaps, and water that soaks into mortar and brickwork and then freezes expands and pushes the material apart. Each cycle widens the crack a little. Over time the bed that holds a pot loses its grip, and a gust is enough to finish the job. A fall of this kind is therefore the end of a process that was already under way before the wind arrived, and the wind only picked the moment.
Wind loads a stack on its exposed sides. A tall, thin stack stands clear of the roof with nothing to brace it, and the weaker its mortar the less it can resist a push. Pots with cowls or aerials fixed to them catch more wind than a bare pot. Chimney brackets for a television aerial add weight and a lever arm at the top of a column that was built to carry only its own weight, which the chimney repairs pages.
Look for the early signs from the ground, in daylight, from a spot where nothing can fall on you. Cracks in the flaunching, gaps between a pot and its bed, bricks that have turned powdery, mortar joints that are open or raked out, plants growing from the top and a stack that leans against the line of the house wall are all reasons to ask a roofer to look before a storm. A stack that has already lost a pot is overdue for that check.
Making the stack safe
The first job on a damaged stack is to remove the danger and keep the weather out, not to repair it. A roofer makes the stack safe by taking away anything loose that could fall, and by covering or capping any open flue so rain does not run down the chimney and into the room below. If part of the stack is leaning, the leaning section may need to be taken down to a point where the brickwork is sound.
Reaching a stack is the awkward part. A chimney on a main roof sits high above the ground, and working at it safely can need a scaffold or a tower. Scaffolding on the pavement or road needs a highway licence from the county council, and we arrange the licence with our scaffolder. The temporary measures used across all kinds of roof, and the point where a temporary measure has to give way to a lasting one, are described in our guide to making a roof safe.
Until a roofer has checked the flue, treat the fireplace and any appliance connected to it as out of use. Broken pot sections and loose mortar can drop into the flue, and the opening at the top may be blocked or partly open to the weather. The check belongs to the person who looks at the chimney, not to guesswork from a room below.
We look at a photograph sent on WhatsApp before a survey is arranged, which helps if you cannot tell how serious the stack is.
The lasting repair: flaunching, a re-bedded pot and what lies beneath
The lasting repair follows whatever the survey turns up. Where the stack below is sound, the repair is a new bed of flaunching and a pot set back or replaced in it. Where the top courses of brick are loose, those courses are taken down and rebuilt first. Where the stack leans or the brickwork is crumbling, a partial or whole rebuild is the way to put it right, and a patch at the top would only hide the problem. Our guides to chimney flaunching and chimney stack rebuilds go through each case.
While the roofer is up there, the flashing is checked. If the lead around the base of the stack was disturbed by the fall or has split, it needs attention before the roof is left, because a leak at that joint will damp the chimney breast inside. MyJobQuote's chimney leadwork page, last updated 22/09/26, gives these figures for chimney leadwork alone: a patch repair "typically costs around £200", a full replacement "averages around £570", plus "a full leadwork replacement costs between £350 and £920, depending largely on whether scaffolding is required".
Repointing and rebuilding costs depend so heavily on the stack that they are priced after a survey. On our jobs the written quote gives a single total price. Lead that is correctly installed can last for over 80 years, according to MyJobQuote, so a repair done properly is worth the time it takes.
A stack shared with a neighbour carries one more step. The Party Wall etc. Act 1996 lists cutting away a projecting chimney breast, and cutting into the building next door to fit a flashing, as work covered by the Act. The building owner gives the notice at least two months before the date on which the proposed work will begin. Our shared chimney stacks guide covers it.
Chimney leadwork figures (leadwork only)
| Patch repair to chimney lead flashing | around £200, chimney leadwork only |
|---|---|
| Full chimney lead replacement | around £570 on average, chimney leadwork only |
| Full chimney leadwork replacement, range | £350 to £920, chimney leadwork only |
MyJobQuote, chimney leadwork page, last updated 22/09/26. Scaffolding is the main variable in the range. These figures cover chimney leadwork alone, not the pot, flaunching or brickwork.
Insurance, neighbours and what to keep
A pot that falls in a gale can be a storm claim, and the Financial Ombudsman Service explains how it looks at those. It says: "We say that a storm usually involves violent winds, usually with rain, hail or snow." It adds: "Rain, hail or snowfall by itself can constitute a storm." Whether your policy covers a falling pot depends on its wording and on how the damage happened, which only your insurer and your policy documents can settle.
Keep the photographs you took before anything was moved, and write down the date and the approximate time the pot came down. Keep the broken pot and a few pieces of the debris if you can do so safely, and keep any quotation for the repair. If the insurer sends a surveyor, a record of what the stack looked like on the day helps the surveyor reach a view, and it protects you if the repair changes the evidence.
The Ombudsman states that a business has up to 8 weeks to consider most complaints, and that you have 6 months from the date of the final response to go to it. That route is for a dispute with an insurer, after you have complained to it first.
A fallen pot that lands in a neighbour's garden or on their roof is a matter to settle with them, in writing, with your photographs to hand. Our storm damage roof repairs guide covers the wider repair after a storm, so the chimney is looked at together with the rest of the roof rather than alone.


