The short answer
No single figure fits every flat roof. HomeBuilding gives EPDM 25-30 years, GRP 25-30 and felt 10-15; Less gives EPDM 30 to 50, GRP 25 to 40 and torch-on felt 10 to 20. Lead lasts longer again, and neither guide promises any figure for your roof.
Lifespans by covering, source by source
Two guides publish lifespans for the three membranes that cover flat roofs. They do not agree, so each figure appears with the page it came from. HomeBuilding's cost guide was last updated on 30 September 2025 and lists approximate lifespans. Less updated its flat roof cost guide on 9 November 2026.
| Covering | HomeBuilding | Less |
|---|---|---|
| EPDM rubber | 25-30 years | 30 to 50 years |
| GRP fibreglass | 25-30 years | 25 to 40 years |
| Torch-on felt | 10-15 years | 10 to 20 years |
Less attaches its own condition to two of its lines. According to Less, GRP fibreglass lasts its 25 to 40 years "with minimal maintenance", and torch-on felt lasts 10 to 20 years "depending on quality and installation". Read each range as a spread of outcomes, not a date on which the roof expires, and not as a promise from either source. Our page on EPDM rubber roofing describes how that covering is laid.
Lead and zinc as the long-life options
Two metals sit well above the membranes in the published figures. HomeBuilding puts a lead flat roof at 60-100 years, and Less calls lead "the longest-lasting option at 50 to 100 years". On zinc, the maker VMZinc says a correctly designed and installed zinc roof "can last in excess of 100 years". That is. a manufacturer describing its own product, which deserves a pinch of caution.
Metal is a different trade and a different price from membrane work. BS 6229:2025, the current standard for flat roofs, is written for continuously supported flexible waterproof coverings. In plain terms that is EPDM, GRP and felt, and lead falls outside it.
A long covering life also depends on the parts around it. Sheet metal laid over a deck that has gone soft cannot outlast the deck, and a membrane taken badly up a wall or over an edge gives out at that junction before the open area does.
When age turns into a replacement job
Once a membrane has reached the end of its range, the job is a replacement, and a few rules come with it. Approved Document L (para 11.2(d)) includes new waterproofing on a flat roof within what it calls renovation. Where more than 50% of a roof element is renovated, para 11.3 calls for the whole element to be upgraded to the Table 4.3 level where that can be done.
A full replacement also goes past the Planning Portal's test for when no Building Regulations application is normally needed, which asks for "Less than 50 per cent of the roof is affected". The route through building control is therefore part of the work, and we check it with the council before the job starts. Falls matter as well: BS 6229:2025 sets "a minimum 1:80 finished fall", and our flat roof falls guide goes through what that means on site.
Published prices span a wide band. MyJobQuote says "In 2026, the average flat roof replacement costs between £1,500 and £6,000" (20 October 2026). Which?, from a survey of 11 traders, prices a single garage of 6m x 3m at £1,400 to £3,500 in felt and £1,950 to £4,000 for a rubber EPDM roof with new boards, both excluding VAT (November 2025).
Published replacement figures
| Flat roof replacement, UK | the average flat roof replacement costs between £1,500 and £6,000 (MyJobQuote) |
|---|---|
| Felt, single garage 6m x 3m | £1,400 to £3,500 (Which?) |
| EPDM with new boards, same garage | £1,950 to £4,000 (Which?) |
MyJobQuote, page dated 20 October 2026, no VAT basis stated. Which?, survey of 11 traders, November 2025, labour and materials included, VAT excluded.
What the survey checks on an older roof
Age alone does not decide whether a flat roof needs replacing, repairing or leaving be, because a roof's condition reflects how it was laid and cared for. Before we quote we survey the roof, covering every part of it and not just the corner that prompted your call.
- The laps and seams in the membrane, and whether any have lifted.
- Upstands and trims, where the covering runs up a wall or out to an edge.
- The outlets, and whether the roof drains towards them.
- Any standing water, which points to a problem with the fall.
- The deck underneath, because a covering is only as sound as what carries it.
You then get one written total price for what the roof needs, with anything else we saw named plainly. If the answer is a patch, our guide to flat roof repairs shows where patching stops making sense, and the wider picture sits on the flat roofing hub page.


