Call 01493 277103

Flat roof prices

What a Flat Roof Costs

Published flat roof figures run from a few hundred pounds for a repair to several thousand for a replacement, and the spread has good reasons behind it. This guide sets out the sourced ranges, what moves a price and how to read a quote.

Get a written quote

Call 01493 277103WhatsApp us

Roofer laying a new mineral felt cap sheet on a flat roof

The published flat roof prices, with their sources

No single number answers the question, so it helps to see the published ranges side by side with their dates. They come from third-party guides, not from Total Roofing, and each one is for a specific job. Which? Trusted Traders, in a survey of 11 traders gathered in November 2025, price a felt flat roof on "a typical single garage (6m x 3m)" at £1,400-£3,500, and a PVC or rubber EPDM roof with new boards on the same size of garage at £1,950-£4,000. Which? says its prices include labour and materials but exclude VAT.

MyJobQuote's flat roof page, last updated 20/10/26, says: "In 2026, the average flat roof replacement costs between £1,500 and £6,000." Its rubber roofing page, last updated 09/10/26, says "typical rubber roofing prices of around £60 per square metre mean the average rubber roof costs £1,050 fully installed". MyJobQuote prints no VAT basis on either page, and none is assumed for those figures.

The ranges overlap, but they are not the same thing. One is for a single garage and one for a replacement in general. A garage roof, a rear extension roof and the flat roof over a bay or a whole bungalow are different sizes with different access, and a price for one cannot be carried across to another. For garages, MyJobQuote's page, last updated 26/10/26, says: "In 2026, the average garage roof replacement costs between £750 and £3,500." The per-square-metre figure in the rubber roofing line shows how MyJobQuote reaches its own example, and it is no way to work out your total.

Your own figure comes from a survey of your own roof. What we give you afterwards is a single written total for the job as described, never a range.

Published flat roof figures

Felt roof, single garage 6m x 3m (Which?)£1,400-£3,500
EPDM with new boards, same garage (Which?)£1,950-£4,000
Flat roof replacement, average range (MyJobQuote)average between £1,500 and £6,000
Garage roof replacement, average range (MyJobQuote)average between £750 and £3,500

Which? Trusted Traders, 11 traders, November 2025, excluding VAT. MyJobQuote pages dated 20/10/26 and 26/10/26 state no VAT basis. Third-party figures only.

What moves a flat roof price

Size comes first, though it is not the only variable, and the survey is where the others are measured. A roof twice the area is not simply twice the cost, because some of the work does not grow with the area. Edges, outlets, the upturns where the roof meets a wall and the trims round the perimeter are needed on a small roof as much as a large one, and on a small roof they make up a bigger share of the job.

The covering matters. Felt, EPDM rubber, GRP fibreglass, liquid coatings and metal sheet all price differently, and their lifespans differ too. The deck beneath matters as well. If the boards are sound, the new covering goes straight onto them. If they have absorbed water, they come up and are replaced, and that is work nobody can price until the old covering is lifted or tested.

Insulation changes the job. A warm roof puts the insulation above the deck, and a cold roof puts it between the joists and relies on ventilation. Our guide on warm roof against cold roof compares the two. Adding or upgrading insulation costs more than a bare recover, and the Building Regulations can ask for it, as a later section explains.

Access is the last big variable. A single-storey roof reachable by ladder is simpler than one above a first-floor extension, and a roof beside the highway may need scaffold, and with it a licence. A scaffold that overhangs a public footway or road falls under the county council's licensing, and we arrange the licence with our scaffolder. A job that needs scaffold carries it inside the written quote, so the total you receive already allows for it.

Felt, EPDM and GRP: price against lifespan

Published lifespans for the three coverings named here overlap but do not agree, so both sources are named. HomeBuilding, last updated 30 September 2025, gives approximate lifespans of 10-15 years for felt, 25-30 years for EPDM and 25-30 years for GRP. Less, updated 9 November 2026, puts torch-on felt at 10 to 20 years, with quality and installation making the difference, and says EPDM rubber membrane typically lasts 30 to 50 years and GRP fibreglass lasts 25 to 40 years with minimal maintenance.

Set those lifespans beside the price ranges and the reasons for a higher price become clearer. A covering that lasts twice as long may justify a higher price for the same area, though that is arithmetic for you to do with your own quote, not a rule. It also helps to ask how the roof is finished at the edges and outlets, since a long-lived membrane still fails at a poor joint. How a roof is installed also affects how long it lasts, and a poor installation can shorten the life of a good material.

Each covering has its own strengths and weak points, and a good installer can explain both. Our guides to EPDM rubber roofing, GRP and torch-on felt describe how each is laid, where each is vulnerable and what to ask a roofer about the details.

Published lifespans, with both sources

  • Felt: HomeBuilding 10-15 years; Less 10 to 20
  • EPDM: HomeBuilding 25-30 years; Less 30 to 50
  • GRP: HomeBuilding 25-30 years; Less 25 to 40
  • Figures are approximate and not promises

Falls, ponding and the cost of a fix that does not last

A flat roof is never truly flat. It is built with a fall so rain runs to an outlet, and the flat roofs that cause trouble are the ones where the fall has been lost. BS 6229:2025, published on 16 December 2025 when the 2018 edition was withdrawn, covers flat roofs with continuously supported flexible waterproof coverings. NFRC reports that it sets "a minimum 1:80 finished fall for general roof areas and internal gutters". Roof designers reading it are told, according to IKO, to aim for 1:40 in order to reach 1:80 on the finished roof.

That matters for cost because a new covering laid over boards that sag or a fall that is wrong will pond just as the old one did. If the fall has to be corrected, the job grows: new decking, tapered insulation or firring strips, and more work at the edges. Most of that cannot be priced from a photograph, because it depends on how the roof sits.

A low quote is not always a low outcome. A patch that costs little and fails within a year gets paid for again, and the second payment comes on top of the first. Our guide to flat roof replacement sets out when a repair has run its course. Whatever the firm, ask what happens to the deck and the fall as well as the covering.

Regulations that can add to the job

A flat roof replacement can bring Building Regulations into the picture. The energy standard, Approved Document L, counts "Replacing the waterproof membrane on a flat roof" as renovation. If more than 50% of the roof surface is renovated, the whole of the roof is upgraded where feasible, with Table 4.3 setting 0.16 against a 0.35 threshold. Where a full upgrade is not feasible or would not pay back within 15 years, the roof goes as far as is feasible within that payback.

In plain words, a flat roof recover may need more insulation than the old roof had, and insulation takes up depth at the edges and doors as well as money. Door thresholds, upstands at walls and window sills can all be affected by a thicker build-up, which is one more thing the survey has to measure. We check the route with the council's building control team before work starts, so that the quote reflects what the job needs.

Asbestos can change a garage job entirely. HSE says: "If the building was built or refurbished before 2000, assume that there is asbestos in it." MyJobQuote's roof asbestos page, last updated 09/09/26, gives the average cost of asbestos removal for a roof in the UK is around £2,750. A garage roof of cement sheets is a different job from a felt roof, so any figure for removal sits apart from the covering price. Our guide on flat roofing and its garage pages go into the detail, including the options for replacing a garage roof.

Government help does not reach the roof covering. The schemes open in England list insulation, such as loft insulation, and heating upgrades rather than roof replacement, so check GOV.UK for what you can get.

Reading a flat roof quote

A good quote describes the job in words you can follow. It names the covering being laid, says whether the deck is kept or replaced, states what insulation goes in and how the edges, upturns and outlets are treated, and explains what is being done about the fall. The total is for that work and follows a visit to the roof.

Two quotes for one roof can differ for a reason you can read. One may keep the deck and the other replace it, or one may include new insulation and the other not. The way to compare them is to put the descriptions side by side and ask each firm to explain any difference, in writing, so you have the answer to hand when you decide. Ask too what assumptions the quote makes about the deck, because the figure can change if boards turn out to be wet once the old covering is up. A lower total that leaves out work the roof needs does not save money; it moves the cost to a later date and a second visit.

With us, the written quote is one total price once the survey is done. The survey covers the entire roof, we report what turned up, along with other faults seen, and the price is for the roof you have, not one from a brochure. A photograph sent on WhatsApp gets a look from us ahead of any survey booking. The flat roofing pages cover each system in turn.

Questions and answers

What would a flat roof cost me to replace?

Published figures vary with size and covering. Which? Trusted Traders, in November 2025 and excluding VAT, priced a felt roof for a typical single garage (6m x 3m) at £1,400-£3,500 and EPDM at £1,950-£4,000. A separate source, MyJobQuote, says the average flat roof replacement costs between £1,500 and £6,000 in 2026. Your own price comes from a survey.

Why do flat roof quotes differ so much?

Quotes differ because the jobs differ: the covering, whether the deck is kept or replaced, the insulation, the fall, the edges and the access. Compare the written descriptions before the totals, and ask each firm to explain what its figure includes and what it leaves out. A short quote that omits the deck or the insulation is describing a smaller job.

Can I work out my flat roof cost from a price per square metre?

Not reliably. A per-square-metre figure is a guide to how a published average is built, and edges, outlets, the deck, insulation and access sit outside it. MyJobQuote's rubber roof figure, for example, is an average for its own example. Your written total comes after a survey of the actual roof.

Does a flat roof need Building Regulations approval when it is replaced?

It can raise Building Regulations questions. Approved Document L treats a flat roof's new waterproof membrane as renovation, so a replacement can trigger an energy upgrade of the whole roof where feasible once more than 50% of its surface is renovated. We check the route with the council's building control team before work starts.

Get a written quote

Tell us about your roof

Hand dressing a lead ridge roll with a wooden bossing stick

10-year workmanship guarantee, in writing

Call WhatsApp Written quote