Call 01493 277103

Flat roofing

Garage Roof Replacement: Felt, EPDM, GRP or Sheets

A garage roof has four realistic routes: felt, EPDM rubber, GRP fibreglass or sheets. Each has different lifespans, prices and limits, and an older sheet roof raises an asbestos question that has to be answered first. This guide sets them side by side.

Get a written quote

Call 01493 277103WhatsApp us

A brick garage with a worn felt flat roof holding water

Four routes for a garage roof

A garage roof is small, and that changes the choice. A single sheet of rubber can cover the whole roof with no join in the middle. A fibreglass shell can be laid in one go. Felt can be built up in layers around a few upstands. Sheets, by contrast, are bolted down in rows and can carry a pitch where a membrane needs a deck underneath. None of the four is right for every garage, and the building under it narrows the field before price comes into it.

Two questions come first. What is the roof made of now, and what sits under it? A deck of boards under a felt roof can take any of the three membranes, once the boards are confirmed sound. A garage with a roof of corrugated sheets on purlins has no deck at all, and a membrane would need one built. And if the sheets are old enough, the material has to be identified before anything is cut, drilled or lifted. That point is covered in its own section below.

HomeBuilding and Less each publish lifespans for the flat coverings. They disagree, and neither figure is fixed, so the table shows both and neither is treated as settled.

Flat garage roof coverings and published lifespans
CoveringHomeBuildingLess
Torch-on felt10-15 years10 to 20 years, depending on the quality of the product and of the fitting
EPDM rubber25-30 years30 to 50 years
GRP fibreglass25-30 years25 to 40 years, with minimal maintenance

Corrugated and fibre cement sheets are not in the table, because neither source gives a lifespan for them. Their own section covers what can be said about them. The wider flat roofing section of the site has a page for each covering.

Torch-on felt on a garage

Felt is the oldest of the three and the one with the shortest published lifespan: HomeBuilding gives 10-15 years and Less gives 10 to 20 years depending on quality and installation. The covering is built up from layers of bitumen-based sheet, bonded to the deck and to each other, and the top layer is finished with a mineral surface or a cap sheet, and the layers go on in a set order.

The felt is attached with heat. On a garage that matters, because the roof sits close to a timber fascia, a boarded eave and sometimes a shared boundary wall. The work area needs checking for what lies near the flame before the first sheet is unrolled, and the edges and upstands are the details that decide how well the finished roof sheds water.

On price, the Which? Trusted Traders survey of 11 traders, gathered in November 2025, gives £1,400-£3,500 for a felt roof on what it calls a typical single garage (6m x 3m). That figure excludes VAT. It is a survey range, not a quote, and the width of it is the point: the spread comes from the condition of the deck, how many upstands there are and how the roof is reached.

Felt suits a garage whose deck is sound, whose roof is a simple rectangle and where a shorter lifespan is acceptable. It also suits an owner who plans to replace the whole garage in time, since the longer-lived coverings would outlast that plan. It is a poorer fit where the roof has many penetrations, or where the owner wants the covering to be one that is not seamed.

EPDM and GRP: the longer-lived membranes

EPDM is a single sheet of synthetic rubber, supplied wide enough that a garage roof can be covered without a seam across the middle. The sheet is glued to the deck and turned up at the edges. HomeBuilding gives 25-30 years and Less gives 30 to 50 years, and the EPDM rubber roofing page explains how the edges are formed.

GRP is a resin and glass fibre shell that sets hard over the deck. It is laid wet, so the roof ends up with no laps at all. HomeBuilding gives 25-30 years and Less gives 25 to 40 years with minimal maintenance. The detail of the process is in the GRP fibreglass roofing page.

For PVC or rubber EPDM with new boards, Which? gives £1,950-£4,000, again for the 6m x 3m single garage and excluding VAT (November 2025). A MyJobQuote cost guide, last updated 09/10/26, works from rubber roofing prices of around £60 per square metre and puts the average rubber roof at £1,050 fully installed. The two sources measure different things and neither states a house size or a VAT basis in common, so they are two reference points and not a total to add up.

Neither membrane works over a weak base, so both need a sound deck. A deck is the layer of boards under the covering, made of OSB or plywood, and it has to be dry, flat and fixed down well. If the boards under an old felt roof have gone soft at the edges, new boards are part of the job whichever covering goes on, and that is one reason the Which? figure carries the words "with new boards".

Rubber against fibreglass

EPDM

  • One sheet, glued
  • Turned up at edges
  • Fixed dry or glued

GRP

  • Laid wet, sets hard
  • No laps in the field
  • Needs a firm deck

Corrugated and cement sheets: identify before touching

Some garages carry a roof of corrugated sheets laid on purlins, with a slight pitch to shed rain. The sheets can be metal, fibre cement or another material, and they cannot be told apart by looking. A grey, mossy corrugated sheet might be asbestos cement or might not. The HSE rule does not depend on appearance: "If the building was built or refurbished before 2000, assume that there is asbestos in it." HSE's A14 guidance adds "AC roofs are always fragile". A fragile sheet can give way under a person, so nobody should climb onto an old sheet roof to inspect it, and a crawl board does not replace knowing what the sheets are.

On the licensing side, HSE lists asbestos cement roof sheeting under non-licensed work when it is carefully removed without being broken up. Sheeting that is broken up or badly damaged moves into the notifiable non-licensed category. When a survey turns up sheets that could contain asbestos, a specialist takes a sample and has it tested.

For waste, HSE's advice is "Use a lockable skip for asbestos". Norfolk County Council says "We do not accept any type of asbestos at any of our recycling centres". Suffolk County Council says you cannot take it to any Suffolk Recycling Centre, though its contractor collects small amounts of household cement bonded asbestos for a fee. Wherever the garage stands, the sheets do not go to the local tip.

MyJobQuote's cost guides, last updated 09/09/26, put an asbestos roof removal at around £2,750 and an asbestos survey at around £325 in 2026. Both are national averages.

Before an old sheet roof is touched

  • Find out when the garage was built or last re-sheeted
  • Treat a pre-2000 sheet roof as asbestos until tested
  • Never walk on the sheets, whatever they are
  • Do not drill, break or power wash the sheets
  • Keep removed sheets whole and in a lockable skip

Concrete sectional garages

A sectional garage is built from precast concrete panels that bolt together on site, and its roof is a separate part fixed to the top of the wall panels. The roof might be a framework carrying corrugated sheets, or a flat deck under a membrane. The walls decide how much weight the roof can be given: a concrete frame is strong in the walls but the roof panels and their fixings are what carry the covering, so the survey looks at the fixings, the bearers and the rafters or purlins before a covering is chosen.

A replacement over this kind of structure has two parts, and each has its own checks. First the old covering comes off, and where it is asbestos cement the rules in the section above apply. Then the new covering needs a base it can sit on. A membrane needs a deck laid to a fall, and the fall it needs is set out in our guide to flat roof falls. Sheets need purlins at the right spacing for the sheet in question, and the sheet maker's data decides that.

Because the panels are standard sizes, the roof edge is a plain line with a lip at the front. That lip is where a gutter or an edge trim goes, and it is where rain leaves the roof. The check on a sectional garage runs from the sheet to the lip to the gutter and the downpipe, because a new covering that sheds water onto a broken gutter only moves the problem to the wall below. Gutter and fascia work on a garage is covered in the guttering, soffits and fascias hub, though the roofline of a garage is a smaller job than that of a house.

Comparing price and choosing

MyJobQuote says "In 2026, the average garage roof replacement costs between £750 and £3,500", in a cost guide last updated 26/10/26. Where one garage falls inside that range turns on the job itself. A small garage with a sound deck and simple edges sits at the low end. A larger roof, a roof with a rotten deck or a roof that needs asbestos sheets taken down properly sits higher. The Which? figures above come from a different survey and a different method, so a quote that falls between them or outside them is not wrong on that account alone.

A written quote is one total price after a survey. When you compare quotes from two firms, check that each one names the covering, the deck, the edges and whether old sheets are removed, because a quote that leaves one of those out is describing a different job. For what shapes a garage roof price, our page on how to keep a garage roof price down goes through the choices.

A rough guide to choosing runs as follows. A felt roof matches a garage that will not be kept for long or a deck that is being replaced anyway. EPDM suits a simple shape that can take a single sheet. GRP suits a roof with awkward edges or several details, since it is laid wet. Sheets suit a garage built to take them, as long as the old ones have been identified. A roof survey can place your garage on that list, and a photo sent on WhatsApp gives us a first look at the roof shape, the edges and the state of the covering before anyone visits.

Garage roof price references

Average garage roof replacement, MyJobQuoteaverage £750 to £3,500
Felt, single garage, Which?£1,400-£3,500
EPDM with new boards, Which?£1,950-£4,000
Asbestos roof removal, MyJobQuotearound £2,750

Which? Trusted Traders, survey of 11 traders, November 2025, excluding VAT, single garage 6m x 3m. MyJobQuote cost guides, last updated 26/10/26 and 09/09/26, no VAT basis stated.

Questions and answers

Which flat roof covering lasts longest on a garage?

Published figures overlap. HomeBuilding gives 25-30 years for EPDM and GRP and 10-15 for felt. Less gives 30 to 50 years for EPDM, 25 to 40 for GRP and 10 to 20 for felt, depending on quality and installation. Both sources put felt shortest. Neither figure is a promise for your roof.

Can I tell if my garage roof sheets are asbestos by looking?

No. HSE's rule is "If the building was built or refurbished before 2000, assume that there is asbestos in it", and a test by a specialist settles the question. Please stay off the sheets, because HSE says asbestos cement roofs are always fragile, and send us a photo on WhatsApp instead.

Is a flat garage roof more expensive than a sheet roof?

The sources here do not price sheets, so no comparison can be made. MyJobQuote says the average garage roof replacement costs between £750 and £3,500 in 2026, and Which? gives ranges for felt and for EPDM on a single garage. Your own roof gets a written total once it has been surveyed, so none of these ranges stands in for it.

Can the old garage roof stay in place and a new covering go over it?

That depends on the old covering and on what lies under it. A sound deck under felt can sometimes take a membrane. An asbestos cement sheet roof is a different matter, because working over it without breaking it needs care, and only a survey can say which case applies to your garage.

Get a written quote

Tell us about your roof

Hand dressing a lead ridge roll with a wooden bossing stick

10-year workmanship guarantee, in writing

Call WhatsApp Written quote