Call 01493 277103

Martham, 9.2 road miles north-west

Roofers in Martham

Martham is a village 9.2 road miles from Great Yarmouth, out to the north-west. Before any slate or tile comes off a Martham roof, we survey every part of the roof, explain the findings in plain words, and ask the council about the conservation area and any listing.

Get a written quote

Call 01493 277103WhatsApp us

Street of 1960s brick bungalows with concrete tile roofs
Modern brick estate houses with concrete tile roofs in a Wiltshire town

Martham's Green, church and conservation area

  • Houses around the Green

    Brooklyn House is listed Grade II (National Heritage List entry 1152386, first listed 4 December 1987) and so is 17, the Green (entry 1051022). Ten listed buildings stand in the area around, which makes a list entry a routine question for a Martham owner.

    A roof change that touches a listed house's character needs listed building consent from the council, so ask before ordering any materials.

  • Martham conservation area

    Martham has a conservation area designated by Great Yarmouth Borough Council. Ask the council whether your road lies inside it before a covering, a chimney or a roof window changes.

    An Article 4 direction can remove further permitted development rights, so check with the council first. Our own survey carries on whatever the answer turns out to be.

  • The marsh and river edge

    Martham lies outside the Broads executive area, though only narrowly. Riverside and marsh ground at the edge may be Broads Authority land, so the full address matters when you ask who decides planning.

    Flood risk differs from site to site. GOV.UK's long-term flood risk service describes an area, not a house, and the Environment Agency's flood map for planning shows a site's zone.

Who rules on Martham roof work

  • Planning: Great Yarmouth Borough Council. Marsh or river edge land may be Broads Authority land: ask.
  • Building control: Great Yarmouth Borough Council's building control team, or a registered approver.
  • Martham has a conservation area designated by the council; check for an Article 4 direction too.
  • Church of St Mary (Grade I): faculty system. Listed houses: listed building consent.

The planning guide explains which roof jobs need permission; the route for your Martham address is checked with the council first.

Map of Martham and the places nearest to it. Map tiles © Esri; map data © OpenStreetMap contributors.

Ask it straight · Martham

Martham roofs: a Grade I church, roof windows, flat roof lifespans and listed houses

Martham parish had 3,766 usual residents at the 2021 Census. The answers below work through four roof questions that a Martham house or its church can raise, one by one: a church, a house with an extra window, a flat roof and a listed home. Rollesby, Bastwick, Hemsby and Winterton-on-Sea are the closest neighbours.

What does roof work on St Mary's, Martham, involve legally?

The short answer

The Church of England's faculty system applies in place of listed building consent. The church is Grade I; planning for outside work is its own question.

St Mary's carries a Grade I listing (entry 1152351, first listed 25 September 1962), the top grade, and is still used for worship as an Anglican parish church, in the Diocese of Norwich. The ecclesiastical exemption therefore covers it. Roof repairs go through the faculty system, and nobody applies to the council for listed building consent. The diocese, and not the council's conservation team, is the office a churchwarden rings first when a roof starts to leak.

The exemption is narrow. Listed building consent is what it replaces; the remaining controls carry on as before. Exterior alterations to the building can still require planning permission, which Great Yarmouth Borough Council decides, and building regulations are handled by the borough's building control team or a registered approver.

A big parish church has a big roof, and the survey is correspondingly thorough: the covering on each slope, ridge and verge detail, leadwork at gutters and parapets, the run of rainwater goods and the timbers that can be seen from inside. What comes back is a plain account that separates parts that have failed from parts that are merely old, so a parochial church council can plan repairs in stages if it chooses. A tall tower or a long nave also means access is settled early, well before any frame goes up, and we arrange the licence with our scaffolder where a frame is going to stand on or over a road.

What a church roof survey covers

  • Covering on every slope
  • Ridge and verge detail
  • Lead at valleys, gutters and parapets
  • Rainwater goods along the walls
  • Timbers seen from inside the roof

Can I fit a roof window to my Martham house?

The short answer

Yes, where the address allows. Part L allows a roof window of no more than 1.4 W/(m²·K), or one rated Window Energy Rating Band B, and a rooflight of 2.2.

Approved Document L (2021, England) puts figures on a replacement. For a roof window the limit is 1.4 W/(m²·K) or Window Energy Rating Band B; a rooflight's limit is 2.2 W/(m²·K). The first number measures heat loss through the unit, so lower is better, while the rating band is the alternative way of showing the same minimum. A like-for-like swap is one job; a new opening cut into a slope is another, because the rafters, the insulation and the flashings around it all have to be dealt with.

Where the house stands matters before any of that. In Martham the conservation area is worth asking about first, and an Article 4 direction, if one applies, can take permitted development rights away. The planning guide explains the permitted development tests.

A listed house is another matter: listed building consent covers any roof alteration affecting character, a rooflight included. On the survey, the existing roof shows what an opening will cost in structure: rafter spacing, the state of the timbers and where a stack or valley sits close by. Our skylights and roof windows page describes the options, and one written total covers the opening, the window and the weatherproofing around it.

Roof window terms

  • U-valueRate of heat loss, measured in W/(m²·K).
  • WER Band BThe minimum energy band allowed for a new roof window.
  • RooflightA window set into a flat or low roof.
  • FlashingMetal edging that seals the window.

How long should a flat roof on a Martham extension last?

The short answer

Two guides give different ranges. HomeBuilding puts EPDM at 25-30 years and Less says 30 to 50, and each also gives figures for GRP and felt.

Lifespan figures for flat roofs come from two guides, HomeBuilding and Less, and they differ on each of the three coverings. HomeBuilding, last updated 30 September 2025, gives approximate lifespans of 25-30 years for EPDM, 25-30 years for GRP and 10-15 years for felt. Less, updated 9 November 2026, gives an EPDM rubber membrane 30 to 50 years, GRP fibreglass 25 to 40 years, and torch-on felt 10 to 20 years depending on quality and installation.

A range is not a promise for any one roof. The deck, the falls, the edge details and the way water leaves the roof all affect how a membrane ages. BS 6229:2025 sets a minimum finished fall of 1:80 for these roofs, and it covers continuously supported flexible membranes, not lead. Standing water that sits after rain is one sign that the fall has been lost somewhere along the deck, and a roof that ponds for days has something to say about the deck beneath.

Approved Document L treats renewal of a flat roof's waterproof layer as renovation, so insulation enters the question as well. The survey looks at the deck from above and from the loft or ceiling below, wherever either can be reached, the outlets and the upstands, and it asks what is under the membrane before any new layer goes on top of it. Our flat roofing page describes the systems in use, from single-ply to fibreglass, and the written price rests on what the deck turns out to need.

Two lifespan guides

HomeBuilding

  • HomeBuilding: EPDM 25-30 years
  • HomeBuilding: GRP 25-30 years
  • HomeBuilding: felt 10-15 years

Less

  • Less: EPDM 30 to 50 years
  • Less: GRP 25 to 40 years
  • Less: felt 10 to 20 years

What if my Martham home is a listed house like Brooklyn House?

The short answer

Listed building consent is needed for roof work that would affect the character of the building. Brooklyn House is listed Grade II, as is 17, the Green.

Brooklyn House is Grade II (entry 1152386) and 17, the Green is Grade II too (entry 1051022). Listed homes keep their permitted development rights, but anything that would affect character needs consent from the council. A new covering, an altered ridge, renewed leadwork or an extra rooflight can each count, so each is raised with the council before anything is ordered.

The order of the steps matters. First confirm the list entry and the grade, which the National Heritage List gives for every listed building. Then establish whether the conservation area adds anything on top. Then survey the whole roof so the council is shown what is failing rather than a guess. A repair that keeps the existing covering is a smaller change than a re-roof, and the council can say which it regards as affecting character.

Lead is the detail to watch on an older house. MyJobQuote says correctly installed lead flashing can last for over 80 years, so an old flashing that is sound can stay while the covering around it is renewed, and one that has split is replaced at the same visit. Flashings tell you a lot: lead that has cracked at a fold or lifted from a wall needs attention even when the tiles beside it are fine.

Listed roof, in order

  1. Confirm the list entry and grade
  2. Check the conservation area
  3. Survey the whole roof
  4. Ask the council about character
  5. Receive one written total price

Martham gutters, cleaning, shared chimneys and costs

Why does rain pour over the gutter of my Martham house?

The fall may have gone. Brett Martin says a gutter should fall "1mm for every 600mm" towards the outlet, so a sagging run or a blocked outlet makes water stand and spill. A joint that has opened can do the same. The survey looks at brackets, joints and outlets together, and the repair follows the finding.

Is jet-washing the moss off my Martham roof tiles a good idea?

Marley says "the use of high powered jet washes is not recommended as it can damage the surface of the slate or tile, thus reducing its expected life considerably". Checkatrade's April 2026 guide puts roof cleaning at £8.50 to £14 per m2, with no VAT basis stated. A surface check shows whether cleaning will help or the tiles are worn.

My Martham neighbour and I share a chimney: what notice is needed?

Where work cuts into a party structure, such as taking away a chimney breast or cutting in a flashing, the building owner must give notice at least two months before the date on which the proposed work will begin. A surveyor is appointed only if the neighbour dissents or does not reply within 14 days. Removing a chimney breast also needs Building Regulations approval.

What might a new roof cost on a Martham semi?

HomeBuilding prices a three-bedroom semi with a 65m2 roof and plain concrete tiles as one that "may cost between £10,000 and £15,000", and says a Welsh slate roof for the same house "might reach £18,000". Those are guide figures from a page last updated on 30 September 2025. Your own price comes as one written figure after the survey, which also decides how much of the structure beneath can stay. Size, covering, access and condition set the figure, not a house type.

Do storm-damaged Martham tiles need to be left as they are?

Before anything is moved, take pictures of the damage from the ground, then ring your insurer. Do not climb up to check; a slipped tile is a job for someone with a ladder, a harness and the right to be on the roof. The Financial Ombudsman Service says "Rain, hail or snowfall by itself can constitute a storm". Our emergency roof repairs page covers making the roof safe.

Have a Martham roof priced

Tell us about your roof

10-year workmanship guarantee, in writing

Call WhatsApp Written quote