The short answer
Not for a small repair. According to the Planning Portal, an application is not normally required while the work stays under 25 per cent of the building envelope and under 50 per cent of the roof. A heavier covering, a chimney breast coming out or a full re-roof changes that.
Measuring a repair against the Portal's guide
Re-roofing carries two conditions on the Planning Portal's page, and both have to be met before an application can be skipped. One is that "Less than 25 per cent of the total 'building envelope'" is affected. The other is that "Less than 50 per cent of the roof is affected". Think of the envelope as the whole outer shell of the house, everything that separates inside from outside: its walls, floor, roof, windows, doors, roof windows and roof-lights. So the first condition is a share of the entire house, and the second a share of the roof alone.
Picture a ridge re-bedded along its length, six slipped tiles put back, or one valley relined. Each touches a sliver of the shell and a minor part of the roof, so each sits well inside both conditions. The Portal's own word "normally" leaves room for the council to see a particular job differently.
Building control is carried out by the council's building control team or by a registered building control approver. If a job sits near either limit, put the question to that team before the first tile comes off. Our roof repair cost page sets published prices against the size of job.
What drags a repair into the rules
Stripping and recovering a big slope is a new roof, not a repair. Once the work reaches past half of the roof, the Portal's test no longer shelters it, whichever covering goes on.
Added weight is the next trigger. The Planning Portal asks for approval where the new covering raises the roof covering's weight by "15 per cent or more". Approved Document A frames a significant change as one where "the loading upon the roof is increased by more than 15%". Because the two texts do not match exactly, a page quoting either should name which. Before the work begins, the Portal wants a structural engineer or surveyor consulted.
Fire behaviour is the third. If the new covering will perform significantly differently in a fire, approval is needed.
- A covering that arrives 15 per cent or more heavier than the one removed.
- The new covering will not perform like the old one in a fire.
- Removing a chimney breast always needs Building Regulations approval. The breast counts as part of the building's structure.
A second gate: the energy standard
Part L of the Building Regulations deals with fuel and power. For a roof, Approved Document L 2021 in England carries a separate threshold. A roof renovated across more than 50% of its surface should have the whole of it improved where feasible, under paragraph 11.3. A flat roof given a fresh waterproof layer is renovation under paragraph 11.2(d), which means a membrane renewal can trigger the energy standard even though no tile is involved.
In Table 4.3 a roof carries a threshold of 0.35 and an improved target of 0.16 W/(m²·K). Paragraph 4.13 sets the fallback when the full target is out of reach: a U-value as low as is feasible while still paying back within 15 years on a simple payback.
A replacement roof window must reach 1.4 or Window Energy Rating Band B minimum under Table 4.2, and a rooflight 2.2 W/(m²·K). Approved Document L 2026 only starts on 24 March 2027, so the 2021 text still governs work until that date.
Planning is a different door
Planning permission is judged under its own rules. Re-roofing a house is normally permitted development under Class C, and a listed home keeps that class, although work done "in any manner which would affect its character as a building of special architectural or historic interest" needs listed building consent. An Article 4 direction can take away rights the national order would give.
Each question is put to the council covering your address. Within the Broads Authority's executive area it is the planning authority, while building control remains with the district council or a registered approver. Our planning guide goes through Class C and dormers in detail.
For our own jobs, the roof is surveyed before we quote, and the planning or building-control route is checked with the council before work starts. Further repair questions sit on the roof repairs hub, and slipped roof tiles is a good place to start for a single fault.


