Call 01493 277103

Emergency roof repairs

Flat Roof Blown Off in High Wind

Wind meets a flat roof broadside, so when the covering lifts at an edge it can peel back in one piece. Here is what to do on the day, and how repair differs from replacement.

Get a written quote

Call 01493 277103WhatsApp us

Inside a loft, old black felt underlay sagging between the rafters with specks of daylight

The short answer

Stay off the roof and keep people away from anything hanging loose, because lifted felt or trim can swing back. Photograph the roof from the ground, protect the room below and ring a roofer for a temporary cover. A repair or a full replacement is decided on survey, and MyJobQuote averages £1,500 to £6,000 to replace one (20/10/26).

Where a flat roof gives way in wind

A flat roof is a deck topped by a waterproof covering that is held down only at its edges and its fixings. Wind passing over it lowers the pressure on the surface, so the covering can lift like a sail once an edge gets loose. The weak places are the edges themselves, the trims that finish them, the joints between sheets and the upstands that carry the covering up a wall.

So damage can begin at a perimeter and work inward. A lifted trim lets wind under the covering, and a lifted corner of felt or membrane lets rain onto the deck below. From the ground you may see a flap of material, a displaced fascia or trim, or the covering lying on the ground nearby.

A garage, an extension, a dormer cheek and a porch can each carry a flat roof. The material may be felt, rubber (EPDM), GRP or lead, and each reacts differently once damaged. BS 6229:2025, the current code, covers flat roofs with continuously supported flexible waterproof coverings. Lead is not part of that scope.

On the day: staying safe and protecting the room

A loose sheet of felt or membrane can swing back in a gust, so keep everyone away from the edge of the roof and from the ground beneath it. Do not go up to hold it down, and do not pull at it from a ladder.

  • Photograph the roof from the ground, from more than one angle, before anything is moved.
  • Look at the ceiling beneath for stains or a sag, and stand a bucket under each drip.
  • If water has reached a light fitting, isolate that circuit and leave the fitting alone.
  • Pick up loose debris from the ground only when the wind has dropped.

A temporary cover fitted by a roofer keeps the rain out until the covering can be mended or replaced, and a repair that begins with a dry deck gives a longer-lasting result than one made over soaked boards. The guide to emergency flat roof repair goes through how that works on flat roofs specifically, and making a roof safe covers the holding stage.

Repair or replace, and the published figures

Whether a flat roof is patched or replaced depends on the age of the covering and how much of it has been lifted. HomeBuilding gives approximate lifespans of 25-30 years for EPDM and GRP and 10-15 years for felt, while Less puts EPDM at 30 to 50 years, GRP at 25 to 40 and torch-on felt at 10 to 20 "depending on quality and installation". HomeBuilding and Less part company on every one of the three coverings.

Dated cost ranges follow, each from its source. The Which? figures exclude VAT, and the other page gives no VAT basis.

Published flat roof figures
JobFigureSource and date
Felt roof, single garage (6m x 3m)£1,400 to £3,500Which?, November 2025
EPDM with new boards, same garage£1,950 to £4,000Which?, November 2025
Average flat roof replacement£1,500 to £6,000MyJobQuote, 20 October 2026

Under Part L 2021, putting on a new waterproof membrane is renovation of the roof, so the building control route is one to raise with the council's team ahead of any work.

Getting the roof looked at

Total Roofing Great Yarmouth looks over every part of the flat roof and not just the lifted corner, because the deck under a torn covering may be wet and trims along the other edges may have been loosened by the same gust. We describe what we find, including anything else we see, and the price comes as a single written sum. A second look at the upstands and the outlets is part of that, since a flat roof that has lost its covering at one edge may be weak elsewhere too, and a gust that lifts a corner can also have strained the fixings along the sides.

Ring 01493 277103 or send photos from the ground to 07880 284133 on WhatsApp. A photo of the lifted covering, the trims and the ceiling below tells us where the survey should start, though a repair price waits for the survey itself, because the deck under the covering cannot be judged from a photograph.

Questions and answers

Can I weigh down a lifted flat roof covering with bricks or boards?

It means a person on the roof in wind, and loose weights can slide off or tear the covering further. Leave the roof alone, look after the room below and ask a roofer for a temporary cover. The covering can be assessed properly once it is safe to work on, and a roofer can say whether it can be refixed.

Does a flat roof that blew off always need replacing?

Not necessarily. A lifted edge or trim can be refixed or patched where the rest of the covering and the deck are sound. A torn covering, wet boards or an old, worn surface points towards replacement. The survey decides which, since the deck beneath the covering cannot be judged from the ground.

What fall should a replacement flat roof have?

NFRC reports that BS 6229:2025 sets a minimum 1:80 finished fall for general roof areas and internal gutters. IKO states that reaching a 1:80 fall means designing for 1:40, as the code of practice says. A flat roof that holds ponds of water may have lost that fall, and the survey looks for it.

Get a written quote

Tell us about your roof

Hand dressing a lead ridge roll with a wooden bossing stick

10-year workmanship guarantee, in writing

Call WhatsApp Written quote