Call 01493 277103

Conservatory roofs

Roof Windows in a Solid Conservatory Roof

A solid roof makes a conservatory warmer and darker. Roof windows let some daylight back, but each one is a cut in the new roof with its own limits, its own flashing and a published price.

Get a written quote

Call 01493 277103WhatsApp us

A clean tiled roof after moss removal

The short answer

Yes, roof windows can be fitted into a solid conservatory roof. Approved Document L allows a replacement roof window 1.4 W/m²K or Window Energy Rating Band B minimum, and each opening must be framed and flashed correctly. Building control and the council are asked about the roof as a whole first.

Why light drops after a solid roof

A glazed conservatory roof lets daylight in across its whole area. A solid roof, tiled or built from lightweight panels with an insulated core, lets in none. The room becomes quieter and easier to heat, and also markedly darker, especially towards the house wall where the old roof gave the brightest light.

The loss is felt most in the middle of the room. Windows in the side walls and doors still admit light, but it falls off quickly with distance from the glass. That is the case for putting daylight back through the roof itself.

There are two routes. A roof window is a flat pane that lies in the slope, parallel to the surface around it. A lantern is a raised glazed structure that stands up from the roof. Roof windows are the lighter and lower-profile option, and the subject of this page. Our page on lightweight warm roofs shows the kind of solid roof they are set into.

The heat-loss limits

Glass is the weak spot in an insulated roof. The 2021 edition of Approved Document L for England sets figures for new elements put into an existing house. Under Table 4.2 the roof is held to 0.15 W/m²K; a rooflight is given 2.2 W/m²K; and the roof window figure is 1.4 W/m²K, or in the alternative a Window Energy Rating Band B minimum, which is the least that is accepted. That Band B is a floor, so a unit that rates higher is fine.

The document treats the two products differently: a roof window and a rooflight each have their own line in the table. The definition of thermal element excludes roof windows and roof lights, so they are judged against their own limits, not the roof's.

In practice, pick a unit that states a heat-loss figure at or below the limit, and ask how it is fitted. A good pane can still leak heat at an untidy junction. A smaller window also loses less heat, which is one reason to choose two modest openings over one large one.

Limits for new fabric, AD L 2021

Roof

  • 0.15 W/m²K
  • The insulated build-up
  • Judged as a thermal element

Roof window, rooflight

  • 1.4 W/m²K or Band B (window)
  • 2.2 W/m²K (rooflight)
  • Judged against its own figure

What fitting one involves

Fitting a roof window means cutting through the new roof. The opening has to be trimmed with its own timbers so the cut rafters are carried, and the window sits in a flashing kit that carries water round it. The build-up of insulation then has to be brought tight to the frame, or cold air finds a path round the edge and condensation follows.

The roof type decides the detail. A tiled solid roof takes a flashing set that overlaps the tiles. A panel roof takes a sealed frame and a flashing designed for a thinner build-up. Both need the opening to be square, level with the slope and supported from below, and both depend on the cut rafters being picked up properly so the roof does not sag round the hole over the years.

The ceiling comes into it. If you want the roof window to read as a skylight inside, with splayed sides, the finish at the opening has to be built to match the ceiling. That is a decision to make before the first cut. Our page on insulating a conservatory roof covers the build-up that the window will sit in.

Rules and cost

A solid roof is itself a new roof, and a new roof must comply with building regulations. The window goes into that same conversation. Where the work changes how the roof looks or is built in a big way, planning may be required too, so check with the council for your address, whether that is the district council, or the Broads Authority for land inside its executive area.

On price, MyJobQuote's published average for a standard mid-range Velux unit is £1,100; a like-for-like swap, with the opening already in place, runs around £100 less (22 September 2026). Neither covers framing a new opening. The figures belong to one brand's unit, not a conservatory quote, and a new opening in a roof needs trimming, flashing and making good on top. A new opening in a conservatory roof is not a swap, and the frame work around it is extra to that figure. Total Roofing Great Yarmouth surveys the roof first and gives one written total for the job.

Questions and answers

Is a roof window better than a lantern?

They suit different roofs. A roof window is flatter, lower and lighter. A lantern gives more height and more glass, and it asks more of the frame. Choose by how much light the room needs and what the structure can carry, and ask for both to be considered at the survey.

Will roof windows leave the room too cold?

Not if the unit meets the limits and is fitted well. The 1.4 W/m²K figure, or Band B, is the standard set for new roof windows in England. The roof around it is held to 0.15, so the glass is the weaker part, and a few small windows lose less than one large one.

Can I send photos of the roof first?

Yes. Photos of the outside roof and the room beneath, sent on WhatsApp to 07880 284133, help us see where the light is lost and what kind of roof you have. The written price still follows the survey, because the structure under the roof decides what can be cut, and a picture cannot show that.

Get a written quote

Tell us about your roof

Hand dressing a lead ridge roll with a wooden bossing stick

10-year workmanship guarantee, in writing

Call WhatsApp Written quote