Call 01493 277103

Conservatory roofs

Adding a Roof Lantern to a Conservatory Roof

A lantern brings daylight back into a room that a solid roof has darkened. It also cuts an opening through the new roof, so the frame, the junctions and the regulations all need a look first.

Get a written quote

Call 01493 277103WhatsApp us

A detached garage with a corrugated cement-sheet roof showing age and lichen

The short answer

Yes, a lantern can sit in a solid conservatory roof, provided the frame is built to carry it and the opening is formed and sealed properly. It counts as part of a new roof, so building control and the council are asked first, and the price is written after a survey.

What a lantern does in a solid roof

A solid conservatory roof, whether tiled or a lightweight panel system, shuts out most of the daylight that the old glazed roof let in. A lantern is a glazed box standing proud of the roof on its own frame, so light drops into the middle of the room while the roof around it stays insulated.

That is why lanterns are a common answer to the complaint that a converted conservatory feels gloomy. The trade-off is that glass loses heat faster than an insulated roof. Approved Document L, Table 4.2, shows the scale: a new roof is held to 0.15, and a rooflight is allowed 2.2 W/m²K. Those are ceilings on heat loss, and glazing sits far above the roof figure, so every square metre of lantern is a square metre of weaker insulation than the roof around it.

Our page on lightweight warm roofs explains the solid roof that a lantern would be built into.

What the frame has to carry

A lantern is heavier and stiffer than the roof panels around it, and it lands on a few supports rather than spreading its weight evenly. Before one is priced, the rafters, ridge and walls need to be looked at so the opening is trimmed with its own timbers and the load runs down into the walls and base.

This is where the existing conservatory frame decides the job. A sound frame can take the opening with the right reinforcement. A frame with loose corner joints, rot or movement in the dwarf walls may need work first, and that changes the figure. Our guide on whether a conservatory can take a solid roof covers the checks that apply to the whole roof, lantern or not.

The weight rule matters too. If the new covering is 15 per cent or more heavier than the old one, Building Regulations approval is needed, and the Planning Portal suggests having the roof checked by a structural engineer or a surveyor before works start.

Checked before a lantern is priced

  • Rafters and ridge, to see where the opening can be trimmed
  • Walls and dwarf walls, to see how the load comes down
  • Existing joints and seals around the frame
  • The line of the roof where the lantern will sit
  • Roof pitch and how water will run off the sides

Where a lantern can leak

Every opening in a roof is a joint, and a lantern has four sides of them. Water runs down the roof, reaches the lantern's upstand and has to be carried round it by flashing and trays, then on down the slope. A flashing that is lifted, a seal that has dried or a gap at a corner lets rain in at that spot.

Condensation is the second problem. Glass is the coldest surface in a warm room, so moist air meets it and water forms on the inside. Look for lantern designs with a sealed glazing unit and an internal profile that drains condensation away rather than dripping it into the room.

If you already have a lantern that drips, send a photo on WhatsApp to 07880 284133 showing where the water appears. The survey covers the whole roof, and you are told plainly whether the fault is at the lantern, at the flashing around it or further up the slope. The wider repair question is covered under conservatory roofs.

Regulations, planning and cost

A solid conservatory roof is a new roof, and the Planning Portal expects a new roof to comply with building regulations, including the structure, energy performance and ventilation. A lantern is part of that roof, so it goes into the same conversation with building control. Where the roof's form or appearance changes substantially, planning may also be needed, and the council for your address can say whether a lantern tips it that way. That includes homes in a conservation area or inside the Broads Authority's executive area, where the planning route differs.

On cost, the published guides price whole roofs, and a lantern is not broken out in them. MyJobQuote's average for a whole conservatory roof replacement is between £3,200 and £6,000 (20 October 2026), and a lantern is an addition to that kind of job. You receive the price in writing as a single total, and it follows the survey, so the lantern's size, the frame work and the roof around it are all settled before you decide.

Questions and answers

Can I fit a lantern to an existing solid roof?

Sometimes, if the frame can take the opening and the extra weight. The roof has to be cut, trimmed with its own timbers and re-sealed, which is a structural job, not a surface one. The rafters and walls are examined on the survey visit, and you are told what was found before you decide anything.

Will a lantern make the room colder?

Glass loses heat faster than an insulated roof, so a lantern is a weaker part of the roof. AD L allows a rooflight 2.2 W/m²K but holds a new roof to 0.15, so a smaller lantern gives up less heat. A sealed glazing unit narrows the gap between the two, though it does not close it.

Does a roof lantern need planning consent?

Ask the council for your address. The Planning Portal says planning may be required where the roof's structure or appearance changes substantially, and a lantern changes the roof's outline. In a conservation area or the Broads the route can differ. Our guide to planning permission for a conservatory roof has more.

Get a written quote

Tell us about your roof

Hand dressing a lead ridge roll with a wooden bossing stick

10-year workmanship guarantee, in writing

Call WhatsApp Written quote