Call 01493 277103

Spray foam removal

Does Spray Foam Cause Condensation?

Foam does not make water, but it changes where water goes. In a roof, trouble starts where damp air meets a cold surface, and foam can shift where that surface sits.

Get a written quote

Call 01493 277103WhatsApp us

Concrete tile roof with moss, lifted tiles and a cracked ridge

The short answer

It can contribute. Condensation forms when warm, damp air meets a cold surface, and foam moves where the cold surface is. The Energy Saving Trust says closed-cell foam "doesn't let moisture pass through it easily", so moisture that gets in has fewer ways to leave.

How condensation forms in a roof

Warm indoor air carries water vapour. When it reaches a surface cold enough, some of that vapour turns to droplets. In a roof the cold surfaces are the underside of the covering and the timbers close to it, particularly on a winter night, so this is where the droplets form if damp air gets that far.

A roof built the traditional way gives that moisture somewhere to go. Air moves through the roof space, in at the eaves and out at the ridge, and carries the damp with it. Marley's ventilation guidance, for a cold roof using a high-resistance underlay, sets 25 mm of eaves ventilation at 15° or less and 10 mm above 15°.

Foam alters the arrangement. It sits where the air used to flow, and it changes which surfaces stay warm and which stay cold. Whether that raises or lowers the risk of droplets depends on the type of foam, how thickly it was applied and how well the rest of the roof keeps rain out. A roof that was ventilated by design and then filled with foam has had its original moisture plan swapped for a different one, and nobody may have checked that the new plan works.

Where closed-cell and open-cell foam differ

The Energy Saving Trust, last updated on 5 November 2026, draws the main line. Of closed-cell foam it says: "Its main drawback is that it doesn't let moisture pass through it easily." Moisture that finds its way behind a layer like that has a hard time getting out again, and a slow leak or a damp patch at the timbers can persist for as long as nobody looks, which in a foam-filled roof can be a long time.

The same page then says, of open-cell foam, "this risk should be much lower". The words are cautious. They do not say that open-cell foam is free of the problem, and they do not describe how large the problem is for any given house. Both are cautious claims that need a survey of the actual roof to settle. A general source cannot tell you what is happening in your loft, and a confident salesperson should not either.

The guide to open-cell and closed-cell spray foam on this site covers how to tell which you have.

Signs in the loft and what they mean

Condensation announces itself in the loft, if you can reach and see the right places. Things to look for:

  • drops or a sheen of moisture on the foam or on exposed nails and fixings;
  • dark staining on boards, battens or the underlay at the edges of the foam;
  • a musty smell that is stronger in the loft than elsewhere in the house;
  • patches of mould on timber where the foam stops short;
  • damp ceilings below that follow no obvious leak.

None of these proves condensation. A leaking tile or a failed flashing can look the same, and telling the two apart is the job of a survey, which follows the stain back to its source and checks the covering above it. A few dated photographs of what you see help the surveyor. Equally, an absence of signs does not clear the roof, because you can only see the surfaces within reach, and RICS says a timber structure under foam "cannot be fully seen or inspected", which means problems can sit out of view.

What to do if you suspect it

Take it as a reason to find out, not as a reason to panic or to rush into removal. DESNZ says that before any decision about spray foam you should take advice from a specialist surveyor, and the sequence below keeps that first:

  1. ask a specialist surveyor for advice on the foam and what it may be doing;
  2. have the roof checked for leaks, because a source of water is easier to fix than a trapped one;
  3. ask your lender what it requires, since removal "will not always guarantee that they will still lend";
  4. choose removal only if the evidence supports it.

Our spray foam insulation removal hub shows what the work involves where removal is the answer. For a first look, loft photographs can be sent to 07880 284133 by WhatsApp, and Total Roofing Great Yarmouth will then survey the roof as a whole and write up one total price for any work the roof turns out to need, together with a plain account of anything else we noticed.

Questions and answers

Is condensation from spray foam the same as a roof leak?

No, though they look alike. A leak brings in rain through the covering or the lead, while condensation is moisture from the household itself landing on a cold surface. Both can leave stained timber and a damp smell, which is why a survey of the roof checks for each before anyone decides what the foam is doing.

Is open-cell foam free of condensation problems?

Not necessarily. The Energy Saving Trust says the risk of rot "should be much lower with open-cell foam", which speaks of lower risk, not a clearance. How a particular roof behaves depends on its ventilation, its covering and how the foam was applied, and only a survey of that roof can tell you.

Will extra ventilation fix it?

Possibly, but foam can block the air paths a roof was built with, and the right fix depends on the roof's design, so adding vents at random may change nothing. Marley publishes eaves ventilation figures that apply to one roof design only. Ask a specialist surveyor to advise on your roof before anyone drills vents or opens up the foam.

Get a written quote

Tell us about your roof

Hand dressing a lead ridge roll with a wooden bossing stick

10-year workmanship guarantee, in writing

Call WhatsApp Written quote