Call 01493 277103

Spray foam removal

Is Spray Foam Bad for Your Roof?

Foam under a roof is neither a certain fault nor a certain fix. Whether it causes trouble turns on the type, the condition of the covering and whether the timbers can be checked.

Get a written quote

Call 01493 277103WhatsApp us

Thick moss on the concrete tiles of a chalet bungalow's north-facing slope

The short answer

Not automatically, but it can hide problems. The Energy Saving Trust says closed-cell foam "doesn't let moisture pass through it easily", and RICS says covered timbers cannot be fully seen or inspected. Only a look at your own roof settles whether the foam is a concern.

Moisture is the worry, and the foam type matters

A pitched roof sheds rain at the covering, but small amounts can still find a route in: a slipped tile, a split in the underlay, a failed seal around lead. In a roof with ordinary insulation, a wet patch has some chance to dry out. Foam changes that picture, depending on which kind was sprayed.

The Energy Saving Trust, last updated on 5 November 2026, says closed-cell foam's "main drawback is that it doesn't let moisture pass through it easily". For open-cell foam it says "this risk should be much lower". Both lines are careful: the risk is described as lower, not as gone.

So the foam is not bad by default. It becomes a concern when a leak lets water reach timber that has a layer behind it that will not let moisture escape, which is why the covering above is checked as well as the foam below. Our guide to open-cell and closed-cell spray foam explains how to tell which you have.

Foam stops anyone checking the timbers

A second problem has nothing to do with moisture. RICS, in its consumer guide, says: "If the timber roof structure is covered with spray foam it cannot be fully seen or inspected." The sentence is short, and its weight is on the word "fully": some parts may be visible while others are buried. The consequence is plain: a roof you cannot inspect is a roof whose condition is unknown, and that is a weaker position than one with exposed rafters and battens that a surveyor can probe with a torch and a screwdriver.

This is why surveyors and lenders raise it. In March 2023 RICS reported "concern within specific sectors of the lending market, such as equity release mortgages". Government guidance published on 22 October 2026 is milder: "Many mortgage providers are open to lending on properties with spray foam, subject to their own requirements."

For your own roof, the foam is not proof of a defect, only a covering over the evidence. A spray foam survey looks at whatever is within reach, from the loft side and from the roof slopes, and says what could not be seen.

Ventilation and the roof's own design

Ventilation is the third issue. Some roofs are built to let air move at the eaves and the ridge. Marley, writing about one type of underlay, gives 25 mm of eaves ventilation at 15° or less and 10 mm above 15°. In a cold roof the insulation lies along the ceiling and air is meant to move through the space overhead. Foam sprayed hard against the underside of the roof can block those paths, leaving the air with nowhere to go.

That matters because a roof designed to breathe and a roof sealed with foam work on different principles, and nobody should combine them by accident. Where foam was added to a roof built with ventilation in mind, someone needs to check whether the original air paths still exist.

The question for a surveyor is therefore broader than whether the foam is present, and a roofer looking at your loft asks it too. They want to know what the roof was designed to do, what has been done to it since and whether the two now fit together.

What to do if you have foam in your loft

Having foam is not a reason to panic, and it is not a reason to order removal on the spot. The roof has carried it for some time already, so taking time to find out the facts costs little. DESNZ says: "Before making any decision about your spray foam, you should take advice from a specialist surveyor." Its paper also notes that removal will not always settle a lender's view, so taking the foam out is no automatic cure.

Sensible steps are:

  1. find out which type of foam you have and what the loft looks like;
  2. ask a specialist surveyor for advice and your lender for its requirements;
  3. have the roof covering, the lead and the underlay checked for faults that could let water in;
  4. decide on removal only once you know what the foam is hiding.

Where work is needed, Total Roofing Great Yarmouth looks over the full roof, lists anything else that turned up, and sets out a single total in writing. If the foam does come out, our spray foam insulation removal hub shows what follows.

Questions and answers

Does spray foam make a roof leak?

The foam itself does not let water in. Water gets in through the covering, the lead or the underlay. What foam changes is what happens next: closed-cell foam, says the Energy Saving Trust, "doesn't let moisture pass through it easily", and covered timbers cannot be fully inspected, so a leak can go unseen for longer than it would in a bare roof.

Is open-cell foam safer for the timbers than closed-cell?

The Energy Saving Trust says the moisture risk "should be much lower with open-cell foam", which describes a lower risk, not a promise. Neither type lets anyone inspect the timbers while it covers them. A survey of your roof, rather than the foam type alone, shows whether there is a problem to deal with, and what it would involve.

Should I have my spray foam removed straight away?

No. DESNZ wants a specialist surveyor consulted before any decision. Ask your lender what it requires too. Removal is not the only route, and DESNZ says it "will not always guarantee that they will still lend", so decide with the full picture rather than on a sales call, and give yourself time to compare more than one view.

Get a written quote

Tell us about your roof

Hand dressing a lead ridge roll with a wooden bossing stick

10-year workmanship guarantee, in writing

Call WhatsApp Written quote