The short answer
Sometimes, in a small area reachable from the loft. A patch lapped over a tear can give a stopgap. A lasting repair means lifting the tiles and battens above and relaying that section of the underlay, and a failing sheet over a whole slope points to a re-cover.
What the underlay does and how it tears
Beneath the tiles sit the battens that carry them, and beneath the battens a flexible sheet is laid over the rafters. That sheet is the underlay, once bitumen felt and now also available as a synthetic membrane. Its job is secondary: the tiles shed nearly all the rain, and the underlay catches stray drops of wind-driven water or condensation and carries them down to the gutter.
A tear can start in several ways. A nail through the sheet where a batten was fixed is one. An old sheet that has gone brittle is another, and a slipped tile can let a sharp edge or a heavy foot press through it. Where a roof was repaired in the past by someone working from above, the underlay around the repair may have been disturbed.
You may find a tear when daylight shows through a rafter bay in the loft or when a stain appears on the felt. Our guide to how to find a roof leak sets out how water travels, which matters because a damp spot on the ceiling need not sit directly below the tear.
Repairing it from the loft
From inside, the underlay can be reached only where the loft is open and a person can see and handle the sheet between the rafters. In that case a patch of matching membrane can be lapped over a tear and stuck or stapled in place, with the upper edge tucked under the sheet above so that water runs over the joint and not into it.
The limits are plain. The tear has to be small and clearly visible, the rafters and any insulation must not block the reach, and the area above has to be dry and sound. A patch seen only from below cannot show what has happened to the batten above it, and it cannot make good the slipped tile that allowed the damage in the first place.
- A small, visible tear within arm's reach: a lapped patch may serve for now.
- A tear under tiles you cannot see into: relay that section from outside.
- Brittle or torn sheet across a slope: ask about a re-cover.
For those reasons, treat a loft patch as a temporary measure until a lasting repair can be made. Work in a loft has its own risks: stay on the joists or on boards, never on the ceiling, and take a torch. If you have a photograph of the tear, send it to us on WhatsApp at 07880 284133, and we can say what it looks like.
Why patches do not last and when to relay
A tear in the middle of a slope sits under tiles and battens, so a lasting fix is made from outside. The tiles above are lifted, the battens are checked, the torn underlay is cut out and a new section is laid with laps that shed water down the slope, and the tiles go back. That is a bigger operation than the tear suggests, and it is why a patch inside is only a stopgap.
The sheet around a patch is as old as the tear, so a patched area can sit beside a sheet that is close to failing. Where tears are spread over a slope, or the sheet is brittle, relaying a section stops being sensible and a full re-cover is the better question. Re-covering reaches more than 50% of the roof, and that lies outside the Planning Portal's test for re-roofing that needs no building regulations application.
The type of underlay also matters. Ventilation depends on the sheet chosen. Marley's eaves figures of 25 mm at 15° or less and 10 mm above 15° apply to a cold roof lined with a high-resistance underlay, which it describes as not vapour-permeable. Swapping one type for another therefore changes how the roof breathes.
What an underlay repair is priced against
An underlay repair has no figure of its own in the published guides, so two wider ones frame it. From MyJobQuote comes a roof repair average of around £650 (6 October 2026), a figure for repairs generally. At the other end sits Which? Trusted Traders with £7,000 to £21,000 for an average three-bedroom house whose whole roof is replaced, excluding VAT (November 2025). Neither is our price, and the written total for a section of underlay comes only after the survey, once the extent of the tear is known.
The survey also looks at what let the tear in: the tiles above it, the battens and the nails that hold them down, along with the rest of the slope. That is the whole-roof view, and it is why we look beyond the area you rang about. The roof repair cost page gathers the published ranges, and the roof repairs hub lists the other topics.


