The short answer
Catch the drips, move anything valuable clear and photograph the window and the stain inside, without climbing out to it. A roofer can fit a temporary cover over the frame, then survey the flashing kit, the seals and the tiles around it before a permanent repair is priced as one written total.
Storm leak or window condensation indoors
Before assuming the window has failed, look at when the wet appears. Water that arrives only while rain is driving at the roof, and runs in from the corners or the top of the frame, points to a leak. Beads of moisture on the glass or along the lower frame, wet on a cold morning and drier by the afternoon, look more like condensation. That comes from damp indoor air meeting a cold surface, and it is not a hole in the roof.
A few checks from the floor tell you more:
- Is the stain on the plaster beside or below the window, or only on the glass and the frame?
- Does it appear in wind-driven rain only, or in any rain?
- Is the lining above the stain dry?
- Does water gather at the bottom corners of the frame and drip from there?
Look from the ground outside as well. A cracked pane, a loose trim or a gap you can see from the garden is worth a photograph. If you cannot tell which it is, send the pictures on WhatsApp to 07880 284133 and we will look at them.
How storm rain gets past a roof window
A roof window sits in an opening cut through the rafters and battens. Around the frame is the flashing kit, a set of metal pieces that overlap the frame and slide under the tiles beside and above it, so rain is carried over the joint instead of into it. Rubber seals and sealant hold the glazing and the opening sash tight. Inside, a lining closes the space between frame and plaster.
In a storm, rain is pushed sideways or even upwards. That can drive water past a stretched seal, through a gap in a flashing corner, or under a tile that has lifted beside the frame and exposed the felt. A blocked channel above the window can also send a sheet of water down the glass and around the frame.
None of this tells you which part has failed from indoors, and the cause can sit outside the window itself, in the tiles or the felt next to it. So the survey takes in the tiles and felt surrounding the opening as well as the glass.
A temporary cover, and what happens next
A roofer can fix a waterproof sheet over the window from outside and secure it so the wind cannot lift it. That holds the rain back while the cause is found, and it is a holding step, not the repair. Our page on making a roof safe sets out what a make-safe covers, and temporary to permanent roof repair explains how the permanent work follows.
Work on a wet, windy roof is not always possible. A roofer judges whether the slope can be reached safely, and if not, the cover waits until it can. Do not try to reach the window yourself from a ladder or by leaning out of it.
Our survey comes ahead of any quote: the frame, the flashing kit, the seals, the tiles around the opening and the felt beneath them. What you receive afterwards is one written total for everything the window needs, and anything else we notice on the roof gets named in plain words. The full emergency picture sits in our emergency roof repairs hub.
Reseal, re-flash or replace: published figures
What the survey finds decides which of these a window needs. A worn seal or a displaced flashing piece is a repair. A cracked pane, or a frame that has rotted at the lining, may mean a new window. The published figures below are averages and ranges from third parties, each figure carrying its source and date, and they are not our prices.
| Item | Figure | Source and date |
|---|---|---|
| Standard mid-range Velux window | £1,100 | MyJobQuote, 22 September 2026. |
| Like-for-like swap into the existing opening | around £100 less | MyJobQuote, 22 September 2026. |
| Emergency roofer call-out | typically £150 to £300 | MyJobQuote, 22 October 2026. |
A replacement roof window also has an energy standard to meet, set out in Approved Document L 2021 and summarised in the questions below. Check the route with the council's building control team before work starts, since the opening, the flashing and the lining are all part of the job.


