Call 01493 277103

Emergency roof repairs

Roof Leak Near a Light Fitting

Water and wiring do not mix, so a leak near a ceiling light changes the order of play. The circuit goes off first, an electrician checks it, and the roof repair follows.

Get a written quote

Call 01493 277103WhatsApp us

Opened roof with bags of removed spray foam on rafters

The short answer

Isolate the circuit at the consumer unit, leave the light switch alone and keep out from under the fitting. Have an electrician test the wiring before anyone turns it back on. The roof is the second call, not the first, because the leak above needs mending whatever the wiring turns out to be.

Switch off before you do anything else

A ceiling light is wired into the circuit above the plasterboard, and water dripping from it, or from the ceiling around it, may be reaching live parts. The first move is to cut the supply to that circuit where your fuses or breakers sit, in the box known as the consumer unit. If you are not sure which one feeds the room, switch off the lighting circuits or the whole house, whichever is quicker.

A few points keep that step safe:

  • Do not touch the fitting, the switch under it or any wet cable.
  • If the floor is wet around the consumer unit, or the unit itself is damp, do not go near it. Leave the house if you cannot reach it dry, and ring an electrician.
  • Do not test the light to see whether it still works.
  • Keep children and pets out of the room.

If a bulb has blown or a circuit has already tripped, treat that as a sign the water has reached the wiring, and leave it switched off.

Why an electrician comes before the roofer

Even once the dripping has stopped and the ceiling looks dry, wiring that has been wet may not be safe. A light fitting can look fine and still have a damp joint or a cable with damaged insulation. Only an electrician can test the circuit and say whether it can be used again, or whether a fitting, a length of cable or a section of ceiling needs replacing.

It is a reasonable order of work: electrician first, because the risk to people is greater, and roofer next, because the leak keeps feeding water into the same place until the roof is mended. If both are needed on the one day, that is fine, but do not let anyone work on the circuit while it is still wet, and tell the electrician the leak is still active so they can plan for it.

Where the leak is sagging the ceiling around the light, read the answer on a ceiling bulging with water before anyone enters the room.

What the loft above the light can show

A light fitting sits in the ceiling, so the loft floor above it carries cable runs, insulation and the joists. If the loft is dry and safe to reach and the power is off, a look from the hatch can show wet insulation, a dark patch on the timber or a drip falling from a batten.

Stay on the joists, never on the plasterboard between them, and keep clear of any cable that is wet or lying in water. Do not move insulation that is soaked around cables; leave it for the electrician and the roofer to deal with together. A photograph from the hatch is enough.

The position of the light does not mark the position of the hole in the roof. The leak can enter at the roof covering some distance away, run along a rafter and drip where the cable passes through the ceiling. That is why the roof needs looking at as a whole, including the slopes either side and any chimney, valley or rooflight nearby.

Getting the roof opening found and mended

When the wiring is dealt with, the roof is the next job. Total Roofing Great Yarmouth surveys the whole roof, not only the slope above the light, and tells you what else we see up there. The survey comes before any price, and the price arrives as a single written sum and not a scatter of figures. A temporary cover can go over the damaged part if the weather is poor before the lasting repair, and temporary to permanent roof repair shows how the two fit.

You can ring 01493 277103 or send photos of the ceiling and the loft to 07880 284133 on WhatsApp; please keep the power off until the electrician has been, whatever the photos show.

Photograph the stain and the fitting before the electrician or anyone else touches them. The Financial Ombudsman Service says it will "usually look at expert reports and photos", and a picture of the ceiling as it was is worth having if you need to tell your insurer what happened.

Questions and answers

Can I turn the light off at the wall switch instead?

The wall switch only breaks the circuit to the lamp, and the wiring above the ceiling can still be live and wet. Use the consumer unit to cut the supply to that circuit, and do not touch the switch with wet hands. If the unit is damp or you cannot reach it safely, stay out and ring an electrician.

Is it safe to use the light again once the ceiling looks dry?

Not until an electrician has tested the circuit. A ceiling that looks dry can hide damp in a joint or a cable, and the fitting may have been damaged by water without any sign. The test removes the guesswork and leaves you with a clear answer on whether the light, the cable or a section of ceiling needs replacing. Leave the circuit off until it has been done, even if you are tempted to try it for a moment just to see.

Should I ring the roofer or the electrician first?

Ring the electrician first, because wet wiring is the greater risk to people in the house. Then arrange the roof. The leak does not stop on its own, so waiting for the roof only lets more water into the same place. Both calls can be made together, and each can work once the other has made the area safe.

Get a written quote

Tell us about your roof

Hand dressing a lead ridge roll with a wooden bossing stick

10-year workmanship guarantee, in writing

Call WhatsApp Written quote