The short answer
Keep people and cars off the ground beneath the ridge, because the tiles still in place may be loose too. Photograph from a distance and tell your insurer. A roofer then re-fixes the ridge, with Marley pointing to mechanical fixing, and Which? puts a new ridge tile at £80 to £300, excluding VAT (November 2025).
What a ridge does, and why its loss matters
Along the crest of a pitched roof, where the slopes on either side meet, runs the ridge. Half-round, angled or specially shaped ridge tiles sit along it and cover the joint, so rain cannot run in at the apex and the tops of the slope coverings stay held down.
When ridge tiles blow off, the joint underneath is exposed. Rain can reach the timbers at the highest point of the roof, and the tiles left on the ridge have lost the neighbours that braced them. Where the ridge was bedded in mortar, a run of tiles can go together if the bed beneath has weakened.
A ridge is also the highest point of the house, so what falls from it has the farthest to go. Pavements, a drive, a car, a neighbour's fence and a conservatory roof are all candidates. For that reason the first job after a gale is to find where the pieces landed, not to look for the cause.
Keeping people clear until the ridge is secured
Do not go up. A ridge is awkward to reach, a wet slope is slippery and a ladder placed against the eaves leaves you under the loose line. From the ground, with binoculars if you have them, you can see how many tiles are missing and whether more look lifted.
- Cordon off the strip below the ridge and the ground at the gable ends for people, pets and cars.
- Collect fallen pieces with gloves once the wind has dropped, and set them aside rather than binning them; the roofer may want to see them.
- Photograph the ridge line from the ground, taking it from more than one side if you can.
- Tell your insurer, and keep the dates of the wind and of when you noticed.
If the weather is poor, a temporary measure over the gap keeps rain out until the ridge can be re-fixed. Making a roof safe explains what that holding measure is, and why it is only a stage. The aim is to stop rain reaching the open joint, hold the loose tiles in place and give the permanent repair a dry roof to start from.
Re-fixing a ridge: mortar, mechanical fixing and dry ridge
The way the ridge was held decides how it is put back. Marley says that "In all cases, ridge or hip tiles should be mechanically fixed to resist the calculated wind uplift force." It also says the 2015 amendments to BS 5534 made it clear that mortar could no longer be relied upon as the only means of securing the roof covering. BS 5534 "isn't required by law", so this is a standard of good practice, not a legal requirement.
A dry-fixed ridge swaps the mortar bed for a system of ridge pieces and fixings, and BS 8612:2018 is the specification that covers such systems for ridge, hip and verge. A roofer can re-bed a ridge in mortar with mechanical fixings, or fit a dry system, and the survey decides which suits the tiles and the roof. Our guide to storm damage roof repairs sets out the wider checks.
What ridge work costs, and how we price it
Published figures differ in what they measure, so each is given with its source. Which? Trusted Traders, from a survey of 11 traders in November 2025, put a new ridge tile at £80 to £300, excluding VAT. MyJobQuote, on a page last updated 1 October 2026, gives £225 to £550 as the average price for replacing ridge tiles. Checkatrade, in its June 2026 table, gives ridge tile repairs at £50 to £70 per metre, excluding VAT. That last figure is a rate per metre, so it cannot be multiplied into a total.
At Total Roofing Great Yarmouth the ridge is surveyed just as the rest of the roof is, including how the remaining tiles are held. What follows is a written quote carrying a single total, so the figure you weigh up is the one you pay for the ridge work, and the same goes for any further repair the survey turns up elsewhere on the roof. Ring 01493 277103 or send a photo of the ridge to 07880 284133 on WhatsApp.


