Call 01493 277103

Conservatory roofs

Noisy Conservatory Roof in Rain

A thin, light roof turns every raindrop into a tap. Read on for why a conservatory roof drums, which small faults add rattles, and what changes the sound, from thicker sheets to a solid roof.

Get a written quote

Call 01493 277103WhatsApp us

Torch beam on a wet patch of underlay and rafter in a loft, tracing a leak

The short answer

Rain hits a thin, light roof and sets the whole sheet or pane ringing, with nothing heavy or soft above or below to absorb it. Thicker multiwall sheets, tightened caps, an insulated lining or a solid roof each reduce the noise. A solid roof makes the biggest change.

Why a light roof drums

Sound from rain depends on what each drop strikes. On a tiled roof, the drops hit a heavy, solid covering over a space filled with insulation and a ceiling, so little of the sound reaches the room. On a conservatory, they hit a thin sheet or a single pane, and the sheet vibrates like a drum skin, sending the sound straight into the room below.

Polycarbonate is light and flexible, so it picks up the impact of each drop easily and passes it on. Glass is heavier and rings less, though a thin glazing unit can still be noisy in a downpour. Large spans between the bars add to it, because a bigger unsupported area can move more.

Every roof differs in this, and how loud a roof sounds in rain also depends on the intensity of the rain and the room's furnishings.

Noise is also one of the complaints a replacement roof is chosen to solve, alongside heat and cold, so it helps to decide which of the three bothers you most before you compare options. The answer changes which option is worth its cost.

Small faults that add rattles

Part of the noise may not be the rain at all. A cap that has lifted, a sheet that has worked loose in its bars or a fixing that has backed off can rattle and tick in wind and shower. These sounds are easier to fix than the drumming, and they are worth ruling out first.

A loose gutter or a lifted flashing at the house wall can also knock in the wind. A close look from outside, along the bars and the eaves, shows what is moving. Putting those right costs less than any new roof and may take the edge off the noise.

Listen from inside during a shower or a windy spell and try to place the sound. A tick or rattle that stays in one spot is a fault, while an even roar across the whole roof is the drumming of the covering itself. Telling the two apart saves paying to fix the wrong thing.

Rattles to rule out

  • Caps lifted along a glazing bar
  • A sheet loose in its bars
  • Fixings backed out at the eaves
  • A gutter or downpipe knocking
  • A flashing lifted at the wall

Options that change the sound

Thicker multiwall polycarbonate has more layers of cells, which damp the vibration more than a thin sheet. It softens the sound without removing it, and the existing bars have to be made for the thicker sheet. Our page on replacing polycarbonate roof panels covers that limit.

An insulated liner under the roof puts a soft layer between the drops and the room, which can also reduce the cold. The risk is trapped damp air, so the liner is fitted with condensation in mind.

A solid roof, with tiles over insulation and a plastered ceiling, is the biggest change. The mass of the covering and the insulation absorb the impact, so rain on a solid roof is a quiet sound in the room. The trade-off is weight and cost, and our page on lightweight warm roofs explains how a lighter build-up can give some of the same effect. Weight matters to the frame, so a heavier roof is only chosen once the structure has been checked.

Choosing, and what to check first

Start with the lower-cost question: is part of the noise a rattle? If it is, tightening and resealing may be enough. If it is drumming on a thin sheet, a thicker sheet or a lining is worth pricing against a solid roof, because the three differ widely in what they change and in what they cost.

A solid roof must comply with building regulations, so we check the route with building control before work starts, and the frame is checked for the extra weight. The survey covers the full roof, and anything else we see is named, then we give one written total price. The conservatory roofs page covers the choices.

If you want a first opinion, a short phone video of the roof during a shower, sent on WhatsApp to 07880 284133, lets us hear the noise and see the bars and the eaves before any visit. Say where you sit when it is loudest, and whether the room is used in the evening.

Questions and answers

Is polycarbonate noisier than glass in rain?

A thin polycarbonate sheet is light and flexible, so it carries the sound of each drop into the room. Glass is heavier and can ring less, although a thin glazing unit is not silent in a downpour. The thickness of the sheet or unit and the size of each span count, not only the material.

Will a thicker panel stop the drumming?

It softens it, because more layers of cells damp the vibration, but it does not remove it. The existing bars also have to suit the thicker sheet. If the aim is a quiet room, a solid roof gives a larger change, so weigh the two on what each one costs and what it solves.

Why does my conservatory roof tick in the sun?

Plastic sheets and the bars that hold them expand and contract with temperature, and they can tick or creak as they move against each other. A sheet that is held too tightly or a cap that has loosened makes it louder. It is a different noise from rain, and a close look at the fixings tells you more.

Get a written quote

Tell us about your roof

Hand dressing a lead ridge roll with a wooden bossing stick

10-year workmanship guarantee, in writing

Call WhatsApp Written quote