When does a Swardeston re-roof go to CNC Building Control?
The short answer
Re-covering the entire roof does, because over half of it is affected. Smaller repairs depend on both Planning Portal ceilings.
The Planning Portal's re-roofing guidance sets two ceilings. No building regulations application is normally needed where "Less than 25 per cent of the total 'building envelope'" is affected, and where "Less than 50 per cent of the roof is affected". Each ceiling has to be met, not just one of them, and the second is measured against the whole roof. A whole-roof strip in Swardeston breaks it, whichever covering is going back, so work of that size starts with a conversation with building control.
Weight is the second trigger. The Planning Portal lists a new covering that raises the roof's weight by "15 per cent or more" as needing approval, and it recommends that a structural engineer or surveyor looks first. Hence the loft inspection: rafters, purlins and wall plates carry whatever is laid on them, so they are looked at along with the slope itself.
Swardeston addresses fall to CNC Building Control, a partnership of five councils (South Norfolk, Norwich City, Broadland, King's Lynn & West Norfolk and Fenland). For this area, calls go to CNC Building Control's Norwich office on 0808 168 5041. CNC's FAQ adds: "If the repair work is significant, or the building is thatched then the Building Regulations may apply." Small jobs sit on our roof repairs hub.
Parts a Swardeston survey inspects
- Tiles or slates: slipped, cracked, loose or missing
- Ridge and verges: bedding, mortar and fixings
- Flashings where roof meets wall or chimney
- Rafters, battens and underlay, seen from the loft
- Gutters and downpipes taking rain off the roof


