How are tiles fixed on a Lessingham roof near the coast?
The short answer
To a site-specific fixing specification under BS 5534, which allows for the site's exposure. BS 5534 is not itself a law, but it is the standard fixings are calculated to.
Within Lessingham, fixings are calculated for the site's exposure under BS 5534. Marley, the tile maker, is clear about the standard's legal status: installing to BS 5534 "isn't required by law". It remains the recognised standard, in its 2014+A2:2018 form, and the specification sets the nail, clip or screw for each tile and for each part of the roof, so two roofs on the same street can carry different specifications, and a specification written for one is never copied across to another without checking the site.
Mortar alone no longer counts. Since the 2015 amendments, Marley says, mortar "could no longer be relied upon as the only means of securing the roof covering". BS 8612:2018 covers ridge, hip and verge parts that are dry-fixed instead. At the survey those parts are looked at for how they are held, and the tiles around them for slipped or cracked units. A ridge that sounds hollow, or a verge with a gap under its cloak, is described in plain words and priced as part of the whole.
Where a whole covering is being replaced, the specification is drawn up fresh for the new covering. Work on the covering itself is described on our roof replacement page, and the written total follows the survey. A new roof for a house here is priced as one figure, after the timbers, the ridge, the valleys and the eaves have all been seen, and any extra fault found is reported with it.
Fixing terms on a Lessingham roof
- BS 5534The standard for slating and tiling fixings.
- BS 8612The standard for dry-fixed ridge parts.
- HeadlapThe overlap between one course and the next.
- BattenThe timber strip each tile hangs from.


